Forget it. I figured it out.
Pull the carpeting behind the brake light. Unclip the assembly, replace bulb.
Because your switch is bad, replace the light assembly
You need a star point screwdriver. Remove the 2 screws pull out light assembly. Remove the light socket from housing and replace bulb. replace in reverse order. 5 minutes.
To replace the tail light bulbs in a 2000 Dakota open the tail gate. You will find two screws on each side that hold the tail light assembly in place. Unscrew these two screws then pull the assembly straight back. There are two pins holding the assembly so do not pull to the side they must come straight back.
how hard is it to remove a flywheel on 2002 volvo s80
In order to get your SRS Service Airbag light reset, You have to go to the Volvo dealership.
Most of the time you don’t have to change the whole assembly, unless its been crushed or broken. The light bulb twists and un screws from the back of the assembly unit.
Look behind the carpet panel in each corner. There you will see access to each light assembly. I believe there are 3 or 4 nuts that needs to be removed. Remove them, assembly should fall out. Then whalahh!
Open tailgate, remove two small torx screws in side, pull tail light assembly from mounting, screw lamp from assembly and replace defective bulb. Reverse proceedure, voila.
how do you replace a blend air door assembly on a 2000 pontiac bonneville
Yes the c70 was in production from 1997 to 2000 after the 840
Open trunk, remove the 2 screws outside the light assembly (right side of light assembly for back light driver side & left side of light assembly on passenger side). Once you remove these 2 screws there are 2 more screws inside the light assembly. To remove the light assembly to access the break light & other bulbs you must work the 2 remaining screws out of the 2 slotted plastic pieces that holds these 2 screws. So you may have to work the assembly left to right & right to left to free up the assembly. Once you replace the bulb line up the 2 screws to the 2 slotted plastic pieces, push light assembly in & screw in the 2 outer screws.