1 Take a week off work and don't expect to using your car for a while. 2 Disconnect the battery and drain the cooling system. 3 Working under the bonnet, disconnect pipes from back of heater assembly 4 Remove the complete facia assembly and steering wheel. (If a passenger airbag is fitted seek further advice) 5 Remove heater assembly and withdraw matrix. 6 Put everything back together with new matrix installed and new o-rings on pipe connector. I did find a shortcut with a Peugeot 405 but the heater was located on the passenger side.
Will 4x100 alloys fit onto Peugeot 306
No
no
fanbelt on a 306 hdi how do fit it
how long to fit heater matrix for citreon relay
check that its not switched on first ........otherwise its the fan speed resistor ..............very costly part easy fit....
nah, different size and shape.
plug it
i dont know how to fit a stater moter!!
Ft
yes it should just have to change a few brackets and pipes
the studs are the same 4x100, whether the offset is correct i dont know, i have seen 206 gti wheels on a 306 dturbo before though