How do you fix a broken door handle on a 1991 Camry and would that be the cause of the door light on the dash remaining on?
fixing the handle is easier than it looks. go to http://www.autozone.com/az/cds/en_us/0900823d/80/14/07/a0/0900823d801407a0/repairInfoPages.htm and look for the diagram picturing the door. it'll break it down for you as far as where the screws are. Inside you will have a liner which you can take down and re-stick after. If your door handle is just loose, your screw probably just fell to the bottom. once you open the plastic, you should beable to see the hole where the screw goes. Problem solved. As far as the door light staying on, no that would be an issue with the door jam located on the door frame (the rubber button). Those are not TOO bad to be replaced. Auto Zone sell those too.
How do you get the door unlatched on a 2000 Chevy Malibu that is not opening with the inside handle or the outside handle and it isn't locked?
What could be the reason for an emergency brake light remaining on and how can it be fixed on a 2002 Kia Spectra?
There is a switch where the brake handle is that activates the light, check it out it may be broken, or stuck, or just need adjustment. Low brake fluid in the master cylinder will cause it as well, and is more often the problem. If you find yourself adding fluid more than once every few months, get your brake system checked for leaks.
What would cause a fire in the engine compartment of a 1997 Toyota Camry following a front end collision?
What would cause the running or tail lights on your 1994 Camry not to work while the head lights brake lights and turning signal lights work?
My steering gets very stiff and hard to turn on my 1999 Camry any reasons why it comes and goes like it does?
The door handle can not be removed till you have the panel off. Remove any screws first ... then slip a screwdriver around the bottom of the panel and start easing it out with a prying motion. follow all around the panel, then lift out vertically against the window. The handle is bolted to the inner door frame. to completely remove the door without breaking the handle housing slip two smaller flat head screw drivers…