I have a 1994 S10 and have had to replace two handles so far. They don't stand up well to stress. I pushed in the inside door panel where the handle is until I could see a "C" shaped pin that holds the handle to its spindle. Then I used needle nose pliers to pull the pin off, the handle will then slip off. When replacing pin, be careful because it will want to sping of the spindle and land somewhere where you can't find it. This happened to me both times.
Inside or outside?
The plastic inside door handle is probably broken.
try this site. http://www.jagsthatrun.com/Pages/Parts_S10-Third-Door-Handle.html
http://www.thirddoorhandle.com/ go to this URL ... it helps alot
log on to eBay and log in seller enigma326 he has complete installation instruction on the page that he is selling the handle.
Yes they are the same
You can use main bearings on a 1995 Chevy S10. The bearings can be purchased at most auto parts stores.
Will a Chevy blazer engine fit in a Chevy s10 pickup
If you have the 4.3 L engine, no.
how to remove the door panel of a 1995 s10
The outside door handle on the driver's side is loose on the right side not the left. I found the screw for the out side left after taking the door panel off but could not find how to tighten the outside right of the handle. How is it connected ?
Use the key.