0
This is an excellent article on how to replace the inner tie rod bushings, which are a common problem. http://www.allpar.com/fix/intrepid-steering.html
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How many rod bearing are in a 2002 Dodge Intrepid?
A 2002 Intrepid has 6 upper and 6 lower rod bearings shells.
How do you replace a push rod in a 3.3l v6 engine on a 1993 Dodge Intrepid?
O,YEA AND I FORGOT TO MENTION IT IS A 1993 DODGE INTREPID...
How do you replace tie-rod on a 1997 Dodge Intrepid?
Inner or outer?
Do you have to pull the engine to change a inner tie rod on Dodge Intrepid?
my dad says you shoulnt have to
Where is the wrist pin on a 1994 Dodge Intrepid with a 3.3L engine?
A wrist pin is the part that connects the piston to the connecting rod.
What is the torque for a 2000 Dodge Intrepid rod bearing bolts?
15 - 20 foot lbs, then an additional 1/4 turn.
What is the torque spec for the rod bearing in a 99 dodge caravan 3.3?
torque for the rod bearing 2000 dodge
Where are Babbit bearings in a Dodge Intrepid?
"Babbit bearings" is a term that was used long ago before engines had fully pressurized lubrication. If an older person heard what sounded like a rod bearing noise in your car that may explain the confusion.
How do you know you if you need too replace right tie rod or rack and pinion bolt on 2000 Dodge Intrepid ES?
When your car comes to slow down to a stop and the front just makes a grinding noise and clunks from like 10mph to stop.
How much does a tire rod cost on 2000 dodge neon?
A tire rod on a 2000 Dodge Neon cost approximately 119.00 to replace. 15.00 at Napa
How do you take off the inner tie rods on a 94 Dodge Intrepid?
its not a fun job. from underneath the hood between the engine and fire wall is the back side of the inner tie rod. there is a bolt with a safety locking tab you have to bend out to loosen the bolt from the rack. jaybird1980
What are the possible causes for a tapping noise on the 2001 Dodge Intrepid Sometimes quiet sometimes loud and sometimes goes away?
Is this coming from the engine? If it is it sounds like you might have some lifter problems. Or the worse part is if you have a rod knocking. Intrepids did have some egine problems.
