answersLogoWhite
Auto Parts and Repairs
Headlights Tail and Brake Lights
Chevy Blazer
Classic 1964-1978 Ford Mustangs

How do you fix the brake lights on a 1994 Chevy CK1500 pickup?

313233

Top Answer
User Avatar
Wiki User
2015-07-15 19:31:19
2015-07-15 19:31:19

make sure FUSE is good- make sure there is 12 Volts on both side of the Brake Light Switch- the brake light wires run THROUGH the steering column-Make sure 12 Volts are on the in & out brake wires.ASSUMING that BOTH bulbs are good & have good GROUNDS.

1

Related Questions

User Avatar

are brake lights staying on or is brake in the dash on ?

User Avatar

i have tail lights but do not have brake lights nor do i have turn signals. i have replaced brake switch and all bulbs

User Avatar

Check the fuse, check the bulbs, then check the brake light switch.

User Avatar

1977 Chevy pickup brake lights not wordking but turn, tail,reverse allworks

User Avatar

If there is no brake lights on a 1998 Mazda pickup, check the fuse. If the fuse has blown, the lights will not work.

User Avatar

You may have a blown fuse or a defective brake light switch.

User Avatar

Yes they indeed have brake lights...

User Avatar

Brake lights indicate when a vehicle is about to stop. When brake lights stop working it is important to check the wiring, the fuse, and the light itself. It could be that any of those need to be replaced.

User Avatar

The brake lights in your 1983 Nissan pickup truck are controlled by the brake light relay switch. When the brake light relay switch malfunctions the brake lights will stop working.

User Avatar

If the brake lights do not work on Chevy Venture van 2000, try to disconnect the brake switch. Then short the two contacts of the connector to check if the brake lights are now working.

User Avatar

on the brake pedal under the dash is a brake light switch. that when you depress the brake it turns your lights on. you might wanna check that

User Avatar

fuse, bad turn siginal switch, bad bulbs, bad bulb socket, bad brake light switch mounted under the dash at the brake peddle.

User Avatar

Assuming you have already checked the bulbs and sockets, next check the fuse, then check the brake light switch, then check the signal switch.

User Avatar

the connection between the battery and the brake lights

User Avatar

Check for a loose connection Check for a loose fuse in the fuse box Check for an open wire in the brake light circuit

User Avatar

I would first check your brake light switch which is attached to your brake pedal under the dash. Since you can turn off the lights by pushing the pedal it is possible the switch is bad. They are around $10.00.I hope this helps you. Mark

User Avatar

It is located just above the brake pedal pad.

User Avatar

its just a fuse, look for a fuse panel there are two. one under the dash and the other under the hood.

User Avatar

If the vehicle is equipped with a trailer light plug, the wires for the brake lights and the turn signals have been connected together, which is common, as many trailers do not have separate lights for brakes and turn signals.

User Avatar

How do I release the frozen brakes on the drum of a 1965 Chevy 3/4 ton pickup

User Avatar

What fuse controls the brake lights on a 1998 Chevy Camaro? It should be labeled on the fuse block.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.