If it is a 2000 Eclipse that has a CD player and a cassette, you need to put in the code and then press the Tape button, radio will come on right away.
The factory radio does not have a reset button.
Hit the AM radio button. You did not say it was a factory radio though.
It displays on the factory radio. There is a button on the OEM radio to either show the time or radio station.
Did you cut factory plug for radio hook up?
If it is the factory radio turn on the ingition and make sure the radio is turned off, push the set button. for the hour push the seek button, for the minute push the scan button, to end push the set button again.
If you have the factory radio this wont be a problem. Turn the radio off. The push in the DISP button, which is the bottom dial below the power button. When the radio display settings, use the seek button until oil life is displayed. Then press the 1 or 2 button util the display says reset. The hold the DISP button again and the light will go off. This process is also outlined in the owners manual under radio. If you don't have the factory radio push the gas pedal down 3 times with the key in the "on" position without the car being on, and this should do it.
its the "tape" button on a 98 probabley the same on 99
Tune radio to desired station, press desired number and hold that button down for several seconds, station is now set to that number.
Where is the radio antenna located on a 2003 Mitsubishi eclipse
Answermost clocks you turn off the radio and use the set buttons Turn radio off with ignition on or running.press set button and use arrow back button for hours and arrow forward button for minutes on oem factory cassette am/fm radio ....hope this helps ..worked for me
For the clock: Turn the radio on Push and hold in the clock button And push the seek button (left) for hours And push the seek button (right) for minutes There is no AM or PM For the radio: Find a radio station on the radio Push one of the selector buttons on the radio and hold it down for about 10 seconds and release Thats all it takes You should have 5 buttons for AM And 5 buttons for FM-1 And 5 buttons for FM-2
The Mitsubishi Eclipse radio code is the code that makes your radio work. You need to put this code in any time you disconnect the battery.