Want this question answered?
http://wiki.answers.com/Q/You_cut_the_horn_on_your_2000_honda_civic_how_do_you_fix_it"
An easy fix is just pull the horn fuse
First Cheack the fuses!!! located under the dash board and check the fuse for the HORN.
Check the fuse first. If the fuse is good apply 12 volts directly to the horn. If it blows then the horn button on the steering wheel or wiring is defective. If not, the horn itself is defective.
When owning a car, it is important to know how much the repair costs run. The cost to replace a horn in a 1988 Honda Accord varies based on the reason why the horn when it out. Generally, it can cost between $20 to $100+ based on many factors.
I took my Honda S-2000 to had my clutch replaced. When I got my car back my radio doesn't work... it powers up but the digital readout read "code6" and if I hit a reset button the readout reads "err". Does anybody know how I can fix this? Thx
If all connections to the horn are fine and the fuse in okay, then you might want to check the horn relay or the actual switch at the steering wheel.AnswerYou will have to check the horn unit to determine if it is broken. This can be done by cutting apart the wiring harness, and connecting wires from your horn to your battery. If it doesn't make noise, your horn is shot. You'll have to take the bumper off the car to get at the horn, another testament of great engineering on the part of Honda :)
To fix the horn on a 1988 Camaro, check the horn fuse first. Then check the horn relay, wiring, horn, and switch to find the problem.
Hi ! In your Toyota Corolla the are is a horn sensor its a unit with belt or coiled wire it connects horn / air bag that one after steering repair you need to set it I think ITS BROKEN you need to buy new horn sensor and fix it. Stanford autos Bukoba Tanzania TEL +255 786 421 000
The horn on a 1997 Acura Integra uses one wire. When a horn stops working it is usually due to a bad fuse. To fix the horn replace the fuse labeled HORN.
Check the horn fuse, and connector on the horn
In reverse the Rincon will pin out at 7mph. To fix this you need to install a reverse override kit.