By replacing the old one with a new one. Do so carefully by removing the starter from the engine first.
One reason that the pull cord on a Weed Eater Blower may have become stuck is because the spring broke. You can try to take it apart to fix it, but it can be difficult. The best option is to bring it into a repair shop.
how do you fix the bike in my sims agents
You will need to loosen the back tire of your bike and pull it back tightening the tension on the chain.
hey, check your card cuz inside there is a float for gas and if its jammed or broken it lets to much gas in so it willbog out!! open the carb and try to fix it!
If the cord broke its acutally not that hard to fix. Take off the cover over the pull starter. Because when you take it off that you don't drop it because in some cases the assembly will just be sitting in there and if you drop it you could have a big mess! Remove all old pieces of the rope. Spin the part the pull rope gets tied to around about 6-10 times. Once you spun it hold on to it and feed in the pull rope. Be sure to only put it in where it will pop though the hole. Pull it thought the hole. Tie a knot it about 2-4 times over each other. Slowly let go and it will wind up. If it doesn't wind up you either have to long of a rope or didn't wind it up enough.
i know you have to take the gas tank off.but i do't know anything else.hope that helps
One can go to a near bike repair shop or a bike selling shop to fix a broken bike chain. In addition, one's peers might know how to fix a broken bike chain.
Take it to Halfords they fix every bike they can because there's nothing else i can think of
well what you would wanna do is go to a computer store or a cord store and buy a new one because sometimes you can't fix shortages so that is what you wanna do to fix a shortage in a cord because that is all i know to do so sorry that is all i know how to do to fix a shortage in a cord sorry :(
No, they only sell you the stuff to fix it with!
yes
Weld it.