Sounds like the problem I just fixed on my '97 Stratus. The flasher is a combo unit for your turn signals and hazard lights. It is located on the top part of the steering column right of the hazard light swith connected to the multifunction switch (turn signal, lights and wiper switch all one unit). The unit is square and not round like most typical flashers. To remove, disconnect the negative terminal under the hood on the left shock tower first. This is to prevent you from accidently activating your airbag. Next move your tilt steering to its lowest position. Then remove the two screws on the steering column cover. Remove cover and just unplug the flasher. Unfortunately, the flasher may be only available from the dealer as it is not a common part (I've checked for days). However, mine came out of a '02 Neon at a wreakers for a quarter of the cost of new. Any Chrysler car using the same turn signal/wiper switch setup should have the part in it. The only mod you may need to do is remove some of the padding on the outside of the flasher to make it fit. .
my turning signals dont work on my 91 integra LS. They were working a day before. so the next day they werent. I also had battery problems but i had checked every single fuse and the fuses arent burn. My turning signals do not work what so ever.
The PA Motor Vehicle Code, § 3334. Turning movements and required signals- says that you will use your turn signals or hand signals when you are turning or changing lanes.
jump start it.
I have found that moisture can cause that problem you may also want to check your fuse and bulbs if you see moisture try to get it as dry as possible
That is a good thing. You want the turn signals to work.
Their is no Possible way :) :(
Check all fuses first. If all of them are good, you probably have a bad multi-function switch. The only way to correct that is to replace the switch. The switch is at the end of the turn signal lever inside the steering column.
Grand theft auto iv
my brother has a 2001 stratus and had problems with the ingnition switch turning forward. we hired a lock smith to repair it at a fraction of the cost.
With my xg 300, the radio was turning on and off on it's own. I checked the battery and it was bad. Replaced it. Now it's fine again. Go to auto parts store and have your battery checked just in case. Could also be loose battery cables.
The flasher is a type of switch that regulates the turning on and off of your vehicle's turn signals and hazard signals.
have you checked the batteries? they could be dead.
It is possible if the flasher relay is going out or has gone bad.
AnswerAre they all controlled by the multi-function lever (Turn signals)?Sounds like a problem in steering column++++REPly==== no they are not in the same switch the head lights pull out from bottom of the dash bord turning signals on the left side and whipers on the right...i checked fuses and relays and no relay for whipers that i can seeo.m.g how many ppl. reed dis?
Have you checked the fuse?
no it does not but if it happens to yours get it checked
turn on your turning signals!
On some vehicles turning the key on, off,on,off,on will make the check engine light flash the code. Three flashes, pause, three flashes would be 33 for example. If that doesn't work you will have to have it checked with a scan tool.
Did you check the fuse? Anyway, it's impossible to answer your question. Re-ask and be very descriptive about what the signals will and won't do.
because of the flashers relay in dash board.
be cause your bulb is blown out
In pa you dont need turn signals
Hello (: I have a 2004 dodge stratus and its fans aren't turning on when their supposed to, but when they do they won't turn off and the sensor isn't detecting the temp, what could be the problem ...?
Have you checked your battery?
Of course not. Indicators are meant to ensure safety while turning a corner or things like that. same to hazards