Pull up on pull tab at center back of seat and fold forward. This releases seat back to fold down.
That's true, but to go all of the way down, you have to take the headrests out of the backrest and install it in the back end of the seat once it has been pulled forward. The pull tab for folding the rear seat on my 2-door is located on the seat portion on the passenger side of the rear seat. Sometimes the latch, which the pull tab releases, gets stuck. It may take someone rocking back and forth in the back seat while the other person pulls on the pull tab to release a stuck latch.
== == == == == ==
There should be a little lever behind the seats. Pull up on this and then the seats will fold down for you.
You can't fold down the seats, they are bolted in...
NO. In the late month of 99 chevy REDESIGNED all the engines and transmissions and NOTHING will interchange from 99 down to 1999 and up.
Unless it is the Luxury edition, the seats do not fold down.
No. Due to the shape of the door and the location of the wheel well the window only goes down part way unlike the Suburban ( longer wheel base ).
not sure about all years, but they do not in the 1999.
That is normal, It is a thermostat
my chevy blazer 1984 the air conditioner blows from down side only.
between the vertical and horvonitoral seat there is a strap up pull up the bottom seat will fold down hten look at the floor u will see a handle/latch for the veritcal seat part, pull hten push seat down.
Normally Remote Start Hold it down a couple seconds
The voltage regulator in the alternator is probley weak. Replace the alternator
It has 4 of them. 2 up streams and 2 down streams
To change the thermostat on a 97 Chevy Tahoe, drain the radiator. Locate the part under the upper hose register and loosen the screw holding it in place. Replace it by putting in the new part and bolting it back down.
those were optional; open the trunk and look at rear of back seats; if you have a vertical split, you have fold-down seats, and heavy canvas-type finger grabs to fold the seat down at the top outside of each seat.
Drop the fuel tank down, disconnect the fuel lines
With modificationof the floor boards for additional bolt down for seat and seat belts.
Unfortunately the Chevy Express of 96 TO 02 does not have folding bench. I don't know for others years.
Your rotors on the front are warped replace the rotors and break pads ane it will be fine
It will if the 99 is the new body style. But if the 99 body looks like all the other bodys from 99 down then NO it will not work.
A single cab has a bench seat, so that would be 1. An extended cab would have 2 buckets seats and in the back would be 2 fold down seats. If you really want to call them seats
In the trunk, their are two tan levers at the top of the trunk, right in the front. Give them them a good pull, and u should hear the sound of the seat's clamp release. Then pull the seats down.
If you law down behind the passenger front wheel and look up at the engine on your side you will see the starter.
under one of the back seats after you fold them down. I think below the fuse box.
The rear window frame is shortened because of the wheel well, to get a full roll down I believe only the suburbans have that capability.I have a 95 Tahoe has the same half roll situation.
follow the wires down the front of the block on the passenger side. on the passenger side of the crank pulley down low you should see a plug.