key does not start the truck and will not come all the way back to lock.
The 1993 Honda accord ignition actuator can be found beneath the dashboard. The actuator will be on the drivers side of the passenger compartment.
the ignition actuator is broken, you can turn off the "battery power" by the the ignition actuator rod that leads to the ignition switch, it runs along the top of the steering column under the dash, locate it and pull it towards the steering wheel, this should shut off the power. or you can unhook you battery, but either way you will have to replace the actuator.
that whole question does not make sence, closest answer is the solenoid on the starter.
what is an ignition actuator i work on Chevrolet and have never heard of it are you talking about the switch
Remove the ignition cylinder retaining ring. Poll the ignition cylinder out. Remove the wiring harness from the back of the ignition cylinder.
"Ignition actuator" is not a standard term... But to try and help, there are a couple of possibilities:Ignition key cylinder - very common problem with the early 90's Taurus/Sables.Ignition control module - requires specialized tool to remove from the side of the distributor.Both of these are covered in the "Related Questions" below...
You can change the ignition cylinder on your 1999 Mercury Mystique by removing the retaining ring at the top of the ignition cylinder. The ignition cylinder will slide out. Remove the wiring harness.
Look under the column, there should be a hole with a recessed release button. Put the key in and turn it back while pressing the release with something small enough to fit in there. I used an awl and it was really easy These instructions actually refer to replacing the Ignition Lock Cylinder. Replacing the actuator usually involoves pulling the steering wheel.
The ignition tumblers are part of the cylinder , they are internal and are what differentiate the key cuts. They do occasionally stick and bind the ignition cylinder
You will need to remove the retaining ring at the top of your 2003 Kia ignition cylinder. The ignition cylinder will slide out. Remove the wiring harness from the back of the ignition cylinder.
Remove the retaining ring at the top of your Chevy S 10 ignition lock cylinder. Slide the ignition lock cylinder out. Remove the wiring harness from the back of the ignition lock cylinder. Reverse the process to install the new ignition lock cylinder.
Begin by removing the retaining ring at the top of your 1994 Ford ignition lock cylinder. The ignition lock cylinder will slide out. Remove the wiring harness from the end of the ignition lock cylinder. Reverse the process to install your new ignition lock cylinder.