Use a Power Steering pulley puller to remove the pulley. This special purpose tool should cost about $8.
Remove the three bolts.
Be happy you thought to ask this question.
Look at the engine end of the upper radiator hose
Engine heat comes into drivers side.
Look in a removable housing at the engine end of the upper radiator hose
$32.49 on ebay, depends on which engine you have and the year.
Look in the removable housing at the engine end of the upper radiator hose.
The air filter is located on the top of the engine. The air filter is enclosed in the air filter housing. Remove the cover to the air filter housing to install the new air filter.
On your 2003 Ford Taurus : The torque converter is INSIDE the bell housing of your automatic transaxle ( transmission ) where the transaxle is bolted to the " rear " of the engine
The 1992 Ford Taurus starter solenoid is bolted onto the side of the starter itself. The starter is at the rear of the engine at the bell housing.
On a 2010 Ford Taurus SHO : The Mass Air flow Sensor is INSIDE the top plastic section of the engine air filter housing
The power steering reservoir is on the power steering pump.Looking from the front of car it is on the passenger side on front of engine. just to the right of the radiator recovery tank.
If you have coolant on the top of the engine it could be a leaky thermostat housing or a leaking intake gasket.
I am not completely familiar with the Taurus, but if you follow the top radiator hose (thick one) back to the engine block, the housing should be located at the point where this hose meets the block. The thermostat is located here inside the Thermostat Housing.