BRIDGE THE TERMINALS GND AND TBS IN THE DIAGNOSTIC SOCKET. SWITCH THE IGNITION ON. THIS WILL CAUSE THE ABS LIGHT TO FLASH. (BY COUNTING THE FLASHES WILL EXPLAIN THE FAULT STORED IN THE ECU. EXPLAINED BELOW.) DEPRESS AND RELEASE THE BRAKE PEDAL 10 TIMES IN 10 SECONDS. REMOVE THE BRIDGE WIRE. THIS WILL TURN OFF THE ABS LIGHT AS LONG AS THE FAULT HAS BEEN CURED. A LOT OF THE TIME IT CAN BE A GLITCH IN THE SYSTEM. LONG FLASH REPRESENTS 10'S SHORT FLASH REPRESENTS UNITS EXAMPLE ONE LONG FLASH FOLLOWED BY TWO SHORT FLASHES EQUALS CODE 12 LEFT FRONT WHEEL SENSOR. 11 RF WHEEL SENSOR 12 LF " 13 RR " 14 LR " 15 WHEEL SPEED SENSORS 22 RF HYD MOD SOL VALVE 24 LF " 26 RR " 28 LR " 51 SYSTEM RELAY 53 PUMP MOTOR / RELAY 61 ECU 63 SUPPLY VOLTAGE HOPE THIS HELPS GOOD LUCK.
What are the head bolt torque specs for a mazda mx3 1600
The Mazda MX3 was first produced in 1991. It was introduced at the Geneva Motor Show in March of 1991. The MX3 was produced until 1998, when production was halted.
yes, you will have to remove all the plastics from the 94 and put them into the 92, as well as the wiring.
This is done the same as the 1995 Mazda MX6. The answer is posted.
well i just changed the brakes on my Mazda mx3 what you do is take the 2 pins out of the calipers which is holding the pads in place and then you are able to remove the pads
waste of time
what size is the motor 1.8 liter
its on the fire wall
By regulating the fuel pressure
there is a plastic cover above the tail light held on by two screws. remove that and simply pull the tail light out.
Under the back seat
its located on the floor behind the consol underneath the dash
bad ignitor or coil .
The last year Mazda made the MX3 was in 1996....... so a 2006 would be really expensive! ;) I guess you are asking about a different car
Mazda has a recall on their seatbelts for some models for this reason. ask a Mazda dealer if your model has the seatbelt recall. I believe the 92 mx3 has a recall for the auto seatbelts, but i am not sure about 93. Look into it though and they might fix it for free!
What causes my Mazda mx3 to turn off while driving down the road.
The flasher box in the Mazda MX3 is the plug in that controls the flashers for the turn signals and also the hazard lights. This part is located under the dash on the driver's side, just above the brake pedal area.
3 1/2 quarts
I found the answer here: http://www.mazdaforum.com/forum/mazda-mx-3-mazda-mx-6-25/water-leak-17642/
lefty loosie righty tighty
In mass air flow sensor.
anywhere between 20-60 depending on material