There may be screws or clips to allow you to get to the light
There are no screws in the dome light cover of a 1997 Toyota Camry. You can pry the cover off with a flat bladed screw driver.
You can remove the rear light cover on your Peugeot 607 by squeezing the tabs located in the middle of the light cover together. Once the tabs are depressed the light cover should come off.
The dome light cover is made of hard plastic and snaps into place. Squeeze the cover just enough to snap it out of place.
AnswerThey are usually held in place by 2 or 4 clips built into the cover. Squeezing or carefully prying the cover sideways and it will come off.I dont need to just take off the cover, because it was busted so bad i have to remove the dome the light is place in. i need to replace the dome, cover, and light.
There are four small four way screws in the cover. Simply take those screws out and the light cover will come straight off.
Yes
Be more specific does the light not turn off, did it explode, or did the cover fall off...
When you open the hatch back there are two screws, take that off and then pop off the light cover and it is there.
Take the cover off the dome light with a flat head screwdriver. Insert the screwdriver carefully into the small indet in the back of the dome light. pry carefully and the cover will pop off. Pull the bulb out and snapo the new one in. For side bulbs you will need to use a Phillips screwdriver and remover the dome light from the ceiling after the cover is removed.
By popping the light cover off and then figure out in your owners manuel how to remove the the bulb.
The plastic cover will pop off. Then remove bulb.
If you need to replace your dome light switch you will need to remove the cover first. You can use your fingernails or even a small knife to get the cover off.