Yes
This one is very easy. Corner light cover is held in with just one screw. Lift hood and just above corner light you will see tab from light with screw connected to frame. Take out screw and light cover can be taken out. You will see wires connected to bulb assembly. To replace bulb, unscrew assembly from cover with twisting motion. Replace bulb assembly into new corner light cover and return new corner light cover to its place...put back screw in tab...done. Hope this helps
Just open the back hatch of the vehicle. When you do that, you will see two screws holding the brake light cover to the vehicle. Take them off, then separate the cover from the vehicle. This will gain you access to the lights.
Pry at the base (from the rear) of the map light cover. There are 2 slots in back that when pryed gently with a screwdriver; will allow you to pull the whole cover forward into your hands. When you are done replacing blubs just pop it back into place.
I Just Came Back from a War was created on 2006-09-26.
The Soldier's Just Came Back was created on 2001-03-28.
all you have to do is unscrew the bolt that's on the tail light cover and the whole thing will come out. Then you just twist the light fixture to pop them out of the cover. Here is a video on how to do it: http://www.youtube.com/watch?v=HqXs8Uk3pbs
how are u? well u have to take out the head light clips which are on the sides of the head light then pull out the head light and uncover the second rubber cover i believe then reach in the head light and turn the socket to the left and and should come out the just change the bulb...when putting the bulb back just turn it to the right and put back the head light and rubber cover and the side clips and that's it...good luck
I just replaced the license plate light bulb on my '95 Blazer. The best way to change it is by laying down on your back looking up at your rear bumper. On the underside of the bumper, just in front of the license plate, you will find two screws holding up the light assembly. Remove those screws and gently pull down the light assembly a couple of inches so you can work with it. You will find that the light is in a plastic cover socket. Turn the light cover while holding on to the base to remove cover. Once removed, you will see a light bulb. Just pull out the old bulb and pop in a new one. Replace the plastic cover and screw the assembly back in the way you found it.
I don't think you can replace just cover. Usually you have to get a new tail light.
The dome light cover is made of hard plastic and snaps into place. Squeeze the cover just enough to snap it out of place.
you just got lucky
You will need a engine scanner to do that. There is a reason that it came on, and if you did not repair the problem then it will just come back on.