1 there is a codder pin that goes through the hub nut and axle, it must be removed. 2 it helps to have a partner, use a pry bar between the lugs to keep the axle from turning, while the other loosens the nut with a breaker bar, and 1 1/4" socket. be sure to use a good socket, cheap may crack and wrenches may bend.
Idle on a 1985 Honda Civic is adjusted through a idle air control valve. This valve is located near the intake. Adjust the valve by either loosen or tightening it.
The idle speed on a 1996 Honda Civic is adjusted using an IACV. The IACV, or idle air control valve, lowers and raises the idle by either being tighten or loosen.
Counterclockwise. Skweekah
No, you should not. You are either tightening the wheel bearing to tightly or too loosely or the bearing race needs replacing. Take the vehicle to a professional and see what is wrong.
The dashboard on a 1991 Honda Civic is held on by several screws. Loosen and remove all of the screws. Then proceed to pull the dash out.
The main bearing torque specifications, for your Honda Civic 1.6 liter engine, is 160 pounds. The main bearing bolts should be torqued in 40 pound intervals.
To remove the stereo off of a 1999 Honda Civic loosen all of the mounting screws for the center console. Pull out the console is loosen the stereo mounting screws. With everything off pull the stereo and unplug the radio.
The spoiler on a 1997 Honda Civic is attached to the trunk. Open the trunk to gain access to the mounting hardware. Loosen the hardware and remove the spoiler.
Yes, tons of them. Might want to specify what bearing your asking about.
take off wheel bearing, put new one on, drink beer, repeat
One can purchase a Honda Civic EK from several different car sellers. One can purchase a Honda Civic EK from a Honda retailer either new or used. One can also purchase a Honda Civic EK from a used car retailer.
A Honda Civic starter is found on the transmission. The starter is mounting with two bolts. Loosen the remove the bolts, then disconnect the starter solenoid from the wire harness. Replace with a new unit.