answersLogoWhite

0


Best Answer

the back bell bolt? need long extension 18mm socket, look over pass side axle while pushing pass side wheel spindle out to back

User Avatar

Wiki User

โˆ™ 2007-10-16 02:09:13
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How do you get to and remove the lower right mount bolt on a v6 engine to transmission on a 1999 Park Ave Buick to separate the engine from transmission?
Write your answer...
Submit
Related questions

Do you have to pull the motor to removeinstall the transmission on a 97 Buick Le Sabre?

No, you do not have to remove the engine.


What would cause a transmission of a1992 Buick lesebre to shrudder as the engine shuts down?

what will cause a transmission in a 1992 buick lasebre to shrudderas and stall engine


Where does transmission fluid go in a 1984 Buick?

Attached to the rear of the engine is the transmission. There is a filler tube coming out of the transmission and it usually has a red dipstick that you remove to add fluid. Dexron 3 is the fluid to be added.


What Kind of transmission does a 1984 buick regal have?

Depends on the engine


Where is starter solenoid on 1991 buick regal 3.8 engine?

between the transmission and the transmission housing


Where is the torque converter on a 1999 Buick Le Sabre?

The torque converter is between the engine and transmission.The torque converter is between the engine and transmission.


What is the oil capacity of a 1991 buick transmission?

Depends on model and engine


Where is the transmission filter located on a 2002 Buick Rendezvous?

If you remove the pan, you will see the filter up in the transmission.


Does a 1999 Buick park avenue transmission fit in a 1995 Buick regal?

Depends on the engine the Park Avenue had in it.


Where is the transmission modulator value located on a 1990 buick regal 3.2 engine?

it should be on the side of the transmission with a black rubber tube from the engine leading to it


Will a Buick or Oldsmobile transmission fit a Pontiac 400 engine?

As long as it has a Buick/Olds/Pontiac bolt pattern on it, it will fit!


Buick lesabre transmission fluid?

Dexron vi Remove and examine the transmission dip stick. It will tell you what fluid is required.


Will transmission from 1997 Buick Park ave. with 3.8lt engine fit 1997 Buick LaSabre with 3.8lt eng?

Yes...


How do you remove the front transmission mount on a 1993 buick lesabre?

It has 2 nuts in the bottom of the frame and three bolts on the transmission case


How do you remove a transmission from a Buick Regal?

Need more information as to the make and model. Some are easy some are hard. No set rule. i have a 2002 buick regal ls is trying to find out how to intall a transmission for it.


How do you check transmission fluid on a 1987 Buick Century?

the red dipstick towards the backside of the engine


Where is the starter located in a 1996 Buick Century?

i belive its on the back side of the engine bolts to the transmission


When changing a transmission in a supercharged 1995 Buick Riviera do you have to take out the engine?

No, just the sub frame.


How many transmission mounts are there on 2000 buick Park avenue?

Two for tranny and two for engine.


How do you know if your Buick is supercharged?

The Buick that was supercharged was called the Ultra. On the engine there is another unit mounted on top of the engine. It is driven by a separate belt from the drive shaft. The engine without the supercharger has only one serpentine belt.


What's the easiest way to remove a transmission on a 91' Buick Regal with a 3.8 liter engine?

Because it is a Transverse Front wheel drive car, the easiest and I prutty sure the only way is to Pull the entire Engine and Transmission Unit out as one part then once you have them out of the car taking the transmission apart from the engine is all down hill, this is a big job so beware.


Transmission from a 86 Buick lesabre be swaped with a 90 Buick skylark transmission?

no!


Is it safe to remove the radiator cap on a 1999 Buick Century when the engine is cool?

Yes.


How do I remove the spark plug wire on 3300 Buick engine?

Pull on it, its just stuck.


Ignition module location on 1990 Buick Century?

You will find the ICM directly below the coils. Just remove the coils and you will be able to remove it. This is on a 1990 Buick Century V6 3300 engine. If you have a different engine I cannot confirm the location.