Ford Taurus
Chevy Corvette
Toyota 4Runner

How do you get to the power antenna on a 1989 corvette convertible?

101112

Top Answer
User Avatar
Wiki User
2011-09-13 04:21:02
2011-09-13 04:21:02

try jacking car up remove tire and wheel look to see if the inner wheel well is removable seems like that's the access to it

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

where is the radio antenna relay located in a 1989 Corvette Convertible

User Avatar

Check your RPO codes. If it has an U75 than it had a power antenna. If it has RPO code US6 it has a painted fixed antenna. There was only one style power antenna used from the factory.

User Avatar

"How to unplug old antenna to replace with standard antenna on 1989 SunDance

User Avatar

= Where is the fuel pump reset switch on a 1989 corvette automatic? =

User Avatar

There is a wire which connects the power to the antenna. The wire is located under the hood right near the back of the fender hump on the passengers side. If you look you will see where it goes down insdie the fender to the antenna power unit. Just unplag the connector and you are good to go. vbdenny

User Avatar

Where is the fuel pump fuse on a 1989 corvette

User Avatar

== == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == == ==

User Avatar

The cause of high engine idle and surges in the 1989 Corvette is due to..Read More

User Avatar

If the antenna is in the up position, you have 2 options, replace the entire assembly, or unplug it. In the trunk under the antenna, you will find a set of 3 wires going into a relay. Unplug those, and the motor will turn off.

User Avatar

Yes , the Chevy Corvette has always been rear wheel drive

User Avatar

Secure the power steering pump with the retaining bolts. Attach the power steering hose to the power steering pump. Put the belt on to the power steering pump. Fill the power steering system with fluid.

User Avatar

I have an 88 celica and my top motor takes power steering fluid

User Avatar

In the trunk on left (driver) side between power antenna and left speaker.

User Avatar

Remove the retaining ring from the top of your 1989 Chevy Corvette ignition switch. Slide the ignition switch out and remove the wiring harness.

User Avatar

The antenna motor is located behind the driver side kick panel.

User Avatar

In my 1989 century, its in the glovecompartment behind a small door with a hole in it. No 3 from top to the right. Problem with the antenna motor running after ignition cut? Hope you excuse my imperfect english. Ray Norway, Eu

User Avatar

The motor that raises and lowers the antenna is controlled by a wire which is connected to the power switch in the stock radio. The wire from the antenna itself has nothing to do with raising and lowering the antenna. Touch the wires that were connected to the stock radio to a hot wire and see if the antenna starts to move. If if does, hook that wire to the wire from the new radio which is supposed to control the antenna motor. If there is no such wire, connect the antenna motor wire to the Accessory circut. The antenna will go up whenever the key is turned on. Or, you can get fancy and install a switch for it.

User Avatar

the computer is under the dash on the passenger side

User Avatar

there is 1 pump in fuel tank

User Avatar

For starters try activating the wiper switch...

User Avatar

Unplug the one pin ECM power connector attached to the positive battery cable. It is usually hidden underneath the power brake booster. Open the connection for a few seconds and then reconnect.

User Avatar

Unplug the one pin ECM power connector attached to the positive battery cable. It is usually hidden underneath the power brake booster. Open the connection for a few seconds and then reconnect.

User Avatar

A person must maintain the fluid levels of a vehicle to keep it running well. The 1989 Corvette Manual transmission holds 3 quarts of transmission fluid.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.