you hit the tolit first you go to the engine pull the black thing and pull it out look threw it and try to get around the engine by cutting the black thing get the engine out be tacking a hammer and hitting it
The shift cable for a 1998 Ford Expedition allows the transmission to be shifted throughout the available gears. It is linked directly from the shift lever to the side of the transmission.
under the center console at the base of the shift lever
Paramedics - 1998 The Night Shift was released on: USA: 5 April 1998
On a 1998 Ford Taurus ; On the column shift the overdrive button is on the end of the gear shift lever On the console shift the overdrive button is on the drivers side of the gear selector lever below the button you have to press to shift out of PARK
There should be a button on the left brake lever that needs to be pushed in, then depress that lever, then shift down and it should then be in reverse. My 1998 trx300 is this way. Hope this is helpful.
autozone.com has online manuals that give step by step how to
It is inside the pintal switch mounted to the top of the transmission. goes over the shift lever.
The most likely culprit is the shift cable. It is either broken or has somehow become disengaged and needs to be reattached. Good luck
Pull the shifter boot up away from the console, look inside on the left side of the shifter is a yellow lever...start car, foot on brake, you should hear a release solenoid click under the dash, above the brake lever. This solenoid supplies power to the shifter release solenoid(inside the console, left side) push down on the yellow lever while lifting up on the shifter release and the car(?) will be able to be moved into other gear ratios. If you release the yellow lever and push the shifter fwd into PARK it will lock again and will require this manual release each time. The yellow lever is the manual release for the solenoid next to the shifter assembly, left side. Either replace it (don't have part number) or manually bend the upper tab of the solenoid that holds the shift lever in park. It's probably cheaper but perhaps not as safe. I could use the part number if anyone has it....
To turn on the highbeams of a 1998 Ford Windstar, bring your lever that controls the wipers toward you and release that turns the highbeams on. To turn off highbeams just push the lever towards the dash.
it is probably that your shift lever bushings have worn out, but check the rubber seals and carpeting, sometimes they put pressure against the shifter making it pop out of gear.
the button will not go in when foot is on brake