With some difficulty. Easiest way would be with three lights connected in series, shining at the same time.
You can link them in series, that is hook the positive from one battery to the negative of the other battery. Then hook the load + to the last battery, and the load - to the first battery. It doesn't matter which one you use as first and last. All batteries need to contain an even charge. +-+-+-+- Here is a website for more information http://www.zbattery.com/Connecting-Batteries-in-Series-or-Parallel:
Sure you can. But consider what could happen if you did. If precision of time or speed was built into this 6-volt system, a 12-volt battery will make it work faster until something shorts or burns out. If you need more lasting power for the 6 volt system, you should consider putting two 6-volt batteries in parallel to power your 6-volt system.
From the factory it will have a 6 volt, positive ground system. However, it is popular to replace the original system with a modern 12v system.
No.
Not being sure of your golf cart voltage, I will give it a try. Count the caps on on batteries, each cap is two volts, so if you have three caps per battery, you have a 6 volt battery. Now count the batteries and multiply by battery voltage, 6 batteries times 6 volts equals a 36 volt system, and so on. You may only charge 12 at time with your charger, so you will have to remove a few battery to battery cables. The cables start with a positive post go to the main system of the cart, with it's neg post connected to the pos. post of the next battery in line, a so on until the last battery in line neg. post goes to the main system of the cart, making a full circle. You must separate the batteries in to 12 volt groups with the main system cables discounted from the main system to prevent damage to it. Remove the neg. cable first, and install it last, safety thing. Need more help contact me through my board and I will try to help.
Separate the 2 12 volt batteries and charge them individually.
Yes, if you have a 12 volt battery and/or a charging system to support it.
Yes
If it is a twelve volt system then you probably need to hook up two jumper cables one to each if it is really dead. if not just hook up the battery on the driver side.
Hook a 12 volt light to a 24 volt system and the light will burn out in seconds. You need a step-down voltage converter to do this.
No.
Get a charged 12 volt battery hook 12 volt constant/RED to the + on the battery then ground - it should power up.
No.
Most 24 volt systems use 2 or 4 12 volt batteries. Be careful not to let the cables get mixed up. They need to be put back in the same spot. Disconnect the battery, Charge each battery individually, Reconnect the cables exactly like they were before. You are ready for work.
The first thing you need to know is if the truck is still the original six volt system or not. The charger is still hooked pos to pos, neg to neg regardless of whether it is pos or neg ground. Do not use a twelve volt charger on a six volt battery.
If you jump a car or other vehicle with a 6 volt electrical system using a 12 volt battery, you can blow out the 6 volt battery. When they are connected, it usually only takes a fraction of a second to start the six volt system. There should be a person ready to start the 6 volt system immediately if not sooner so the 12 volt system can be disconnected immediately before the battery overheats and burns out.
To get 24 volts from two 12 volt batteries, hook the positive post from one battery to the negative post of the other.