Want this question answered?
Normally goes to the starter or starter solenoid.
cheese bacon o wasbi matters which model
Follow the + battery cable its the small part of the starter where the wires hook up
Using the starter solenoid jump the small middle terminal with the starter terminal at the rear of the solenoid
The large one from the positive side of the battery attaches to the large post mounted on the starter solenoid and a smaller purple wire that attaches to the small post on the starter solenoid marked "S". The small post on the starter solenoid marked "R" is not used with that vehicle. Any accessory power wires would also attach to the large post on the starter solenoid.
On the solenoid on top of the starter, Should only be 3-4 there one of which will be your pos batt cable, assuming you are replacing starter.
Yes but you have to hook it to the mounting bolts. You will get just as good of a ground if you hook it to the frame of the tractor. Hope this helps.
I assume you mean a starter solenoid. Look at how the old one is hooked up. Put the new one in that way. ...and disconnect the battery first.
un hook the negitve on the battery. then unhook all the wires from the back of the starter solenoid. then put the two bolts that hod the starter to the block, should be out after that.
You can't miss it- there is a big lug bolt with nut on solenoid on top the same size as hole on end of cable.
Yes Some have 6 or seven wires going to between one and four connection's.
I have had my starter solenoid short out and go bad and keep on trying to start the engine even after I turned the key off. I had to disconnect the battery to stop it and buy a new starter solenoid and install it !