Not very easily, that's how. I have the 99 Quest, and I think it is very similar to the 93 (except for the second sliding door).
I took off the left tail light cover and spliced into the blinker,brake and light wires there. Then I ran one wire from the right side to the trailer harness for that side. Dont forget to ground it too.
Not very easily, that's how. I have the 99 Quest, and I think it is very similar to the 93 (except for the second sliding door).
I took off the left tail light cover and spliced into the blinker,brake and light wires there. Then I ran one wire from the right side to the trailer harness for that side. Dont forget to ground it too.
very easy .I bought my wires on eBay ,,,the trailer harness plugs right into your lights no cutting at all
You will find the tail light harness under the back of the vehicle. Unplug the harness and plug in the trailer harness between the two vehicle connectors. The kit should also contain instructions.
How does one reset service engine light on 2000 Nissan Quest Thanks Bill
The light assy has to be removed and the bulbs removed from the back.
Check your fuses and look for a dead-short on the tail light wire (probably brown).
find wiring harness in the back of the vehicle the same one that goes to the tail lights wire it through that wiring harness use test light to make sure you arein the right wiring harness
i do not yet doing that but i just know that the light for the gearshift is located at the dash board light
I have a wire "whip" that was tucked into the compartment that houses the jack and tire wrench. There should be a harness that is gray and stuffed somewhere with the jack. Attache your trailer lights to this harness. It should be about 6 feet long.
You can access the Nissan taillights from the cargo compartment. Remove the tail light assembly cover. Remove the tail light wiring harness. Remove the tail light assembly retaining bolts.
You will have to buy a harness from the Dodge dealer that will let the trailer lights work without messing with the computer that runs the taillights on the truck. The kit will have the harness and instructions. If you hard wire the trailer into the truck taillights the "lamp out" light will come on on the dash and the turnsignals will flash fast.
Yes. If you are referring to a "tow behind" or a light weight trailer model.
u can buy one at the auto parts store and they plug into the tail light harness usually buy unpluging it and pluging in the harness