It's supposed to be under the hood on Stud #2 30 amp. I tested mine and the fuse is good and the block has power, but I get no power in the plug in the rear still :(
check your fuses
That would be the idea. The light reminds you are in 4x4
The Nissan 4x4 pickup 2.3 was produced from the years 1990 to present in the United States. The spark plug gap on a 1986 Nissan 4x4 pickup 2.3 is .044.
I have a 2005 Chevy Silverado 2500HD ext cab 4x4 long box. My brake lights work on the truck but they do not work on the right side of the trailer plug on the truck. I have checked the wiring and plug from the plug to the gas tank and I could not find a problem. Do you have a suggestion on where or what to look at next?
the 4x4 might not be engaged right
there is a reverse light switch that you can purchase it is pretty much plug and play. it is located on the side of the transmission housing
Flashing light indicates it is not in 4X4 but is attempting to. light should stay solid when 4X4 is locked in. Are you trying to go into 4lo or 4hi?
no you have to be over 25 to drive a horse lorry or a 4x4 pulling a trailer your not allowed to drive at 16 let alone drive a horse trailer!
Dash lights are supposed to light at startup so you know they work. The 4x4 is not working so the light won't come on other than at startup.
Your 4x4 fuse probably blew out.
It is a rubber plug in the front cover.
Check fuse and headlight switch itself. The switch and its plug are probably melted.
Honestly if you don't know where the drain plug is, don't mess with the vehicle then!
www.motorcraft.com shows the spark plug gap as .044 inch
It is the plug for the 4x4 switch on electronic shift 4x4 F-150's. Ford just uses the same wiring harness for all the trucks.
4x4 indicator light
this indicates that the 4x4 is ingaged or that the sensor think that it is. if you have a push button 4x4 most times it is not disengaging from 4x4 try going backwards a few feet after taking it out of 4x4 mode to see if this does not help .
First uf all, The computer has nothing to do with the 4x4 on this year truck. If your check engine light is on , Then there's a problem in the system wiyh the engine or transmission, Not the 4x4. You need to check the 4x4 Actuator on the front housing to see if it has power going to it when you ingauge the 4x4. Check it with a test light. If it lights up the test light, Then replace the actuator in the housing. If it don't. Then go to the top of the Transfur case and you will see a switch on it. Check it with a test light, With the 4x4 ingaged, if its hot there then replace that switch. Before you do anything check the 4x4 Fuse's in the fuse box with a test light.
mitsubishi recommend 1000kg for a 4x2 and 1500kg for the 4x4.
1998 ford f150 5.4 liter v8 triton 4x4 20 amp fuse is not blown but has no power to it for the trailer stop & turn but has running lights