answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you insert clip art if a place holder for art is not included on the slide?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What sets aside a portion of a slide and serves as a holder for text or other content such as pictures?

place holder


What is A region of a slide reserved for inserting text or graphics?

Place Holder


How can you insert slide in power point?

You can insert slide by the Insert Slide option. In 2007, there is the option of New Slide on top.


What is the region of a slide reserved for inserting text or graphics called?

Place Holder


How do you you change a battery in a sentry V360 wall safe?

This is from the Sentry Web Site:How do I insert the batteries on my standard electronic lock?To power the lock, four alkaline AA batteries, are required.To install batteries:· slide open the battery cover located just below the keypad.· Insert a paper clip or pen point into the small hole in the cover.· Push in while sliding cover to the right.· Disconnect and remove the battery holder.· Insert the 4-batteries as indicated.· reconnect the connector and put back the battery holder.· Slide the cover back in place.


What is slide holder?

Its a holder u hold on the side.


How will you the insert the clip art into a slide?

Select the slide, search My Collections for clip art, then select the clip to insert into the slide.


Where is the slide in a microscope?

Microscopes don't normally come with the slides. Microscopes have a place to insert slides that you have prepared separately. See the instructions for your microscope to locate the place where you would place the slides. You put the slide in to view its called a specimen what you put in it.


How can you insert a slide in a PowerPoint presentation?

Ctrl+M


When you insert a new slide it will usually contain for content?

no


How do you put the slide properly on a microscope?

by sliding it right side up between the two clips on the slide holder


How do you remove the cup holder in 2001 Chevy Venture?

pull out the cd holder in the bottom, and remove 2 7mm screws. pull the entire holder out and move to side (keep the two wires to the accessory plugs intact). Pull the cup holder out and remove the two 7 mm screws in the back, pointing up. the entire bezel should now come out. With the bezel in your hand, remove the two phillips screws holding the slide base in place. put the new cup holder in place, with one side of the slides engaged. with the holder all the way back, push up until the opposite side slide is engaged. reassemble