First and foremost, make sure you have a diagram before removing the old belt. If there isn�t one under the hood, get out the pencil and paper and draw it out labeling the pullies and arrows pointing to the direction the belt travels on them. Save this paper in the glove compartment when the job is done for future reference. As far as replacing goes, it depends on the engine. Believe it or not, they are different amongst manufacturers, makes and models, so Bclear! If there is a spring loaded tensioner, you�ll need to turn the tensioner back to relieve pressure, and slide the belt off the tensioner pulley. Depending on the tensioner, you may be able to use a socket wrench with the right socket, 3/8� drive with socket wrench, or in some cases, you�ll need a tool that is meant for just this called a belt tensioner wrench. After it is relieved of tension, the belt can be removed. The new one gets routed the same, if you can�t remember, refer to your diagram. If you didn�t make one and can�t remember, listen closely and you�ll hear me laughing at you. Some belts require motor mounts to be removed and some are just plain nasty, such as the 1.9 motor found in Ford escorts. If there is no tensioner. Look for a bolt going through a bracket that the alternater or Power Steering mounts to. Loosen the bolt, pry back whatever components keeps tension, and replace the belt. Make the tension respectfully taunt and tighten bolt back down after the belt is replaced.. New answer No diagram to install belt: 96 Aerostar Serpentine belt has a flat side and a grooved one. All grooves fit in only one way and flat part travels on the non grooves. Pushing with your hand (left to right) on the tensionner from the top, you can slip the last part of the belt (non grooved) on with the other hand.
For a 1994 Ford Aerostar , 3.0 ( and 4.0 ) 3 - 6 2 - 5 1 - 4 front of Ford Aerostar
Yes they are compatible
1994 Ford Aerostar Mini Van 1994 Ford Aerostar Mini Van
On a 1994 Ford Aerostar , 3.0 L ( and 4.0 L ) 3 - 6 2 - 5 1 - 4 front of Ford Aerostar
On a 1994 Ford Aerostar , 3.0 liter V6 and 4.0 liter V6 : 3 - 6 2 - 5 1 - 4 front of Ford Aerostar
My friend said his ford Aerostar was front wheel drive? ------------------------------------------------------------------------------------ As far as I know the Ford Aerostar has always been rear wheel drive or all wheel drive capable
On a 1994 Ford Aerostar : Other contributors have previously answered : ( 20 or 21 U.S. gallons )
No, they are two completely different designs. aerostar is rear wheel drive ,taurus front wheel drive.
The fuse diagram for my 1994 Ford Aerostar is located on pages 339 to 345 of the Owners Guide that came with the vehicle when we purchased it new.
I'm not a mechanic / technician , but a 1994 Ford Aerostar is OBD I , EEC IV so there should be an EEC TEST connection in the engine compartment
Huh?
23 gal