Want this question answered?
There is a wiring harness most everywhere you look on that and any vehicle. Be more specific.
The factory wiring harness for the trailers will plug in under the back of the vehicle in the area of the spare tire, the harness plugs into the wiring harness for the tail lights.
Visit auto parts store and order Hoppy 43105 harness. Remove interiorrear panel just above bumper and interior driver side rear quarter panel (where the jack storage is). You will find an unused wiring harness that is taped out of the way. Use this to connect it to the harness and route the wiring into the jack storage area.
Begin by removing the wiring harness from the back of 2004 Volvo headlight. Remove the headlight assembly retaining bolts. Reverse the process to install your new headlight assembly.
It is different. The 2008 uses a completely different wiring type.
you can buy a wireing harness that just plugs into your existing wires at a parts store, you do not have to cut any wires! just unplug back by your bumper and plug in the new plug. that's it.
It is pretty easy, go to the stereo shop and buy the install kit as well as the wiring harness adapter for your vehicle. All you have to do is follow the directions and match up the wires of the new stereo wire harness with the adapter you have purchased. Remove the old stereo, install the mounting hardware. It should plug right in to the factory wire harness and snap in place.
Yes depending on if you have on star or not requires different harness
Yes it is different. I have a 2004 FLHTPI. The wiring harness for the FLHTPI is set up for the extra lights and accessory plugs for the additional equipment/electronics that the police bike is outfitted with. I tried to install the air temp and oil pressure gage in the dash and could not match the schematics on the installation instructions to the wiring harness. I had to bring it in to have the gages hooked up. I plan to add a stereo and will run into the same issue with the wiring harness. I haven't found any good resources on the internet regarding solutions yet.
Remove the fog light retaining bolt. Remove the fog light wiring harness. The fog light will come out. Reverse the process to install the new fog light.
Join www.trailvoy.com Posted in the resources section
The 2004 Dodge Intrepid oxygen sensor can be found on the back of the air cleaner housing. Remove the wiring harness. Remove the oxygen sensor retaining screws. Reverse the process to install the new oxygen sensor.