Yes it is different. I have a 2004 FLHTPI. The wiring harness for the FLHTPI is set up for the extra lights and accessory plugs for the additional equipment/electronics that the police bike is outfitted with. I tried to install the air temp and oil pressure gage in the dash and could not match the schematics on the installation instructions to the wiring harness. I had to bring it in to have the gages hooked up. I plan to add a stereo and will run into the same issue with the wiring harness. I haven't found any good resources on the internet regarding solutions yet.
it looks like a road map
Hey Ray==I presume the fuse is blown is why you think there is a short. You have to examine the wiring to find where the wire is shorted out. If you have a trailer harness, start there. If the vehicle has been wrecked. look there as body men have a habit of pinching wires in the repair. If not, you just have to follow the wiring harness and find out where it is. Goodluck, Joe
The ISO standard for electrical wiring in a road vehicle depends on the vehicle. The ISO's include 1185:2003, 1724:2003, and 3731:2003. The ICS standard is 29 and 31.
INFINITE times ,permanent, perfect CHUTIYA
None.In standard single phase wiring there are 3 wires: hot (black), neutral (white), and ground (green). Each has a different purpose and none can be used for any other purpose.
A john Deere Dealer. The wiring harness comes in 3 different pieces. The last time I checked the three totaled about $1,000.00.
Standard 2 Piece Harness Up To Late 1990
No.....They look the same but they are not the same. The wires have been put in different places.
There is a wiring harness most everywhere you look on that and any vehicle. Be more specific.
it will not work the wires and connectot are different
You can find an external wiring harness for a 1971 Evinrude 25 Hp outboard at different boating shops. You can also check with the manufacturer.
NO. The computer and the wireing harness is different and so is the fuel pump / pressure.
The purpose of the wiring harness is to help keep wires together instead of hanging freely. You can purchase a new wiring harness at any auto repair shop.
The wiring harness can be removed by unplugging all of the wires. The wiring harness is also held in place by several retaining screws. Remove the retaining screws.
The factory wiring harness for the trailers will plug in under the back of the vehicle in the area of the spare tire, the harness plugs into the wiring harness for the tail lights.
It depends on which Harness you are looking for.
the harness