All key systmes are electirical switches. Just like a toggle switch except for with a key for security. Get a switch at a parts store and wire it in between the power source and the ignition. If magneto then wire it to ground the mag.
No matter what dirt bike you are riding you will want to install the switch via the ignition coil. Obviously based on the dirt bike you will need to find a convenient place for the key switch but make sure you run it through the ignition coil. Especially if you have both a electric and kick start on your dirt bike.
I assume it is your bike.If it is, unplug the lead from the key behind the headlight - it is a 4 way plastic connector. Bike will now start.
You can start it very easily, Cut the wires leading to the key and if there is only 2 you should be able to recreate the currency of a key and start it up.
Depends on the year. If the bike has the key switch under the seat (right hand side) install the key and turn the switch clock wise to the on position. Make sure the kill switch is set to run. Pull the enricher knob out (the round knob on the left side of the bike under the fuel tank.) Press the start button until it starts.
Cut the wires leading to the key and if there is only 2 you should be able to recreate the currency of a key and start it up.
is this a complete question ^^ ?... i would say, insert the key in the little key hole, turn the power on, then pull the clutch in... and hit the start button... but that's just me
put they key in, turn it, pump the kicker, and pull the throtle,
coil on side of fly wheel broke of can refit but want to rewire bike from start to finish key start to cut of switch to coil whole bike but need to know lay out of wiring of bike and replace all wireing
The turn off key located below the front fender is used to cut off the power running from the stator to the bike, so when you pull it out the bike will not run. you can take the key out so no one can start it.
Have someone use your key and start it or install an aftermarket remote starter.
most quads are key start so they use a key to start them and are called electric start quads and some quads use a pull start to start like a push lawnmower and are called pull start quads
Well if it is your bike and you dont have a key you could just drill out where the key goes and use a screwdriver. and if it is like a ttr then i think you can pop the key switch out.