answersLogoWhite

0


Best Answer

a side goes to engine

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you install a muffler has a A and B on the ends for a 1990 Chevy full size g20?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What rear ends will fit your 1990 g20 Chevy van?

any other van the spring stales are too far apart for any other vehicle .


What is an exhaust pipe?

That big pipe on the bottom of your car with the cat and muffler on it, ends in a tail pipe, squirts pixie dust.


When was Here's Where the Story Ends created?

Here's Where the Story Ends was created in 1990.


Instruction how to install radiator hose for NISSAN 240sx 1990?

use a screw driver and remove hose clamps on both ends of radiator hose, remove hose, wooow is this question a joke?


What are the release dates for TaleSpin - 1990 All's Whale That Ends Whale 1-13?

TaleSpin - 1990 All's Whale That Ends Whale 1-13 was released on: USA: 26 September 1990


What is the weight of a Chevy Astro?

1990-2005 Chevy Astro weighs 3897lbs The previous post above is from Adeyfk. I own a 1990 Chevy Astro AWD Van. AWD Vans weigh more. I called the Chevy Dealership and gave them my vin # and was told the gross weight was very close to 6,000 lbs. and one other web site said the same. Not all vans weigh the same. Some of the older models had extended back ends and/or heavier AWD frames.


What is the name of a Chevy that ends with the letter A?

Beretta, Impala, Lumina


What year Chevy 1500 rear ends fit?

what year chevy 1500 pu fit its a 1997 will a 1999 fit


Replacing rear brake lines 1999 Chevy blazer ls 4x4?

The brake lines can be replaced by removing all of the retaining clips. The brake lines will need to be disconnected on both ends. Reverse the process to install the new brake lines.


Where are the oxygen sensors on a 1999 silverado?

They are screewed into the exhaust system / Pipes. Start were the exhaust bolts up to the engine and work your way back to the muffler and you will find THEM. There could be up to 4 oxygen sensers on yours. There about 3 to 4 inches long and have an electric wire pluged to the ends of them. There will not be any after the muffler.


You are having problems removing the screws that fasten the wires in your stove to the bake element is there anyway to loosen the screws as they are really stuck?

If you are changing the element just cut the wire ends off and install new wire ends. The new element should have new screws with it. you will need a crimping tool to install the new terminal wire ends.


Where can you find photos of interior rear end differential gearing?

eBay under Chevy rear ends