I think you are looking for the slave for the clutch? It is bolted on the driver side of the transmission. Remove the hyd. line then the retaining bolts. Install the new one, bolt it up then put the line on, you may leave the bolts a bit loose to aid with the the hyd. line alignment. Once everything is tight, open the bleeder screw, mach sure you have a good level in the reservoir. If it does not bleed the air off by gravity alone you may need to force the issue. Two people are required for this, with the bleeder tight push the clutch in, with the pedal held in that position open the bleeder, after air escapes re-tighten the bleeder, now the clutch pedal can be released, continue until only fluid comes out of bleeder.
How do you replace a slave cylinder in a 96 chevey k1500
you must remove the clutch slave cylinder and line. Then unbolt the starser and install the new one
How much labor will cost a person in order to install a clutch slave cylinder on a 1998 S10 will depend upon how much labor charges are. It should take a mechanic no longer than 30 minutes in order to install the clutch slave cylinder.
Inside bell housing. Transmission has to be removed to gain access to the slave cylinder/throw-out bearing.
The slave cylinder is actually built onto the throw-out bearing. If you have a problem with it you will have to pull the trans.
The slave cylinder is inside the trans. If you need to replace it you will have to pull the trans out. Its not that bad, its a afternoon though.
the slave cylinder is bolted to the drivers side of the transmissions bellhousing,the reservoir for it is on tne drivers side firewall
how do you connect the hyraulic master cylinder to the clutch slave cylinder on a 2000 chevy S10 pickup 2.2 4.cylinder
oil leaks
Inside the transmission bell housing. The transmission must be removed to gain access to the clutch slave cylinder.
The clutch bleed valve on a 2.2 liter Chevy Ecotec engine is located on the slave cylinder. To find the slave cylinder remove the battery, as it is mounted underneath the battery tray.
You will need to remove the transmission to replace the clutch slave.