You should buy the steering lock plate tool. It makes it easy. You can buy a really nice expensive one from a professional tool dealer, but a lot of the auto parts stores can sell you a cheap-o version that will get the job done for around $20.
there is no button inside the car pull the license plate down in rear and fill her up.
you will have take the air bag off if equipp the steering wheel turn signal switch and lock plate
The gas cap is under the rear license plate. If you have automatic door locks, make sure your doors are unlocked, or you will have in the trunk what looks like a door lock that slides, slide it to unlock your license plate. Then put the gas cap on the right side of the plate to hold it open and pump your gas. At least that is how it works on my 1984 Cadillac Fleetwood Brougham Coupe, that has power everything. Hope this helps : > )
turn steering wheel to full left.behind drivers front wheel on inner fender look for an inspection plate. remove plate valve should nowbe exposed
First I'll say is that if you are not a well seasoned tech, not an easy task to perform. Basically its positioned right below the signal switch. So if you can reach down that far into the steering column, there it is. Depress the locking plate and remove.
Honda quad had no vin plate the number is stamped on a plate in front of the steering shaft
What you have is called the lock plate for the steering wheel. Go to your favorite auto parts store and ask them for a lock plate hold down tool. It will be needed to depress the plate's spring, so the snap ring can be removed that is holding the lock plate onto the steering shaft.
behind licence plate
Under the steering wheel is 2 copper plates with something like a sponge material between them. disconnect the wire on that plate until you can replace the plate or buy a momentary pushbutton to install instead about $4.00.
youll have to remove the air bag pad and horn contact pad and steering wheel. there is then underneeth a steering lock plate , yull need a steering wheel puller for(also for remoal of the steering wheel) and also to depress the spring loaded lock plate to remove the c-clip then slowlly release the pressure on the lock plate and remove it underneah will be the signal light switch assmbly.
Rear license plate lights replacement require that you remove the entire frame with reverse lights. Remove the 3 cover bolts on the inside of trunk, remove license plate, remove the for bolts holding frame to tyrunk lid, slide unit down and out and you will have to twist the bulb sockets and remove the bulbs and install in reverse.
You can purchase Cadillac license plate frames online at either Amazon or eBay. You might also want to check your local car retailer, the usually can order them at the manufacturer and sell them to you.