0
How do you install a thermostat on a Chevy small block engine such as the 350?
Wiki User
∙ 16y ago
The thermostat is located in a removable housing at the engine end of the upper radiator hose Drain about 1 gallon of coolant from the radiator Remove this housing Note how thermostat is installed Clean both surfaces Replace thermostat and gasket Re-install housing Re-fill coolant slowly to prevent an airlock Start engine and look for leaks Run engine to normal operating temperature with heater on Re-check coolant level
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Where is the thermostat located on a 1995 Chevy cavalier with a v6?
Follow the top radiator hose back to the engine block. The thermostat is inside the housing where the radiator hose connects to the block.
How do you change out thermostat 1983 Chevy Caprice?
Where the upper radiator hose connects to the engine the thermostat is located under the neck protruding from the block.
Where is the thermostat located on a 1988 Chevy Blazer S-10?
The thermostat is inside the small housing where the top radiator hose connects to the engine block.
Where is the themostat located on 1999 Chevy Lumina?
Follow the upper radiator hose to the engine block. The part the hose is connected to is the thermostat housing. The thermostat is under it.
Where is the thermostat located on a 2001 Chevy Monte Carlo SS?
It is normally where the upper radiator hose meets the engine block.
Is a Chevy 3100 engine block and a Chevy 3400 engine block the same?
No
What position do you install the cam bearings on a 307 small block Chevy engine?
Turn them so the hole lines up with the holes in the block.
Where is thermostat located on a 1999 Chevy Silverado?
follow your top radiator hose to the engine block. the hose will be attached to the thermostat housing. the housing is attached to the block with two bolts. remove the radiator hose from the housing, remove the two bolts, and gently separate the housing from the block. you will see the thermostat. The above answer is for a V6 engine. If your engine is a V8, follow the lower radiator hose toward the engine. The thermostat, housing & o-ring are one piece.
Intake air temperature sensor location on a 1994 Chevy 454 big block?
The 1994 Chevy 454 cubic inch big block engine temperature sensor is located on the front of the engine. The engine temperature sensor will be a few inches above the thermostat housing.
Where is the thermostat located on a 1999 Chevy Metro?
Where the upper radiator hose goes into the engine block. Disconnect the hose, and the t-stat should be inside the engine.
Why is there a hose from the water pump to the intake manifold on a big block Chevy engine?
That is a by pass, so the water can transfer around the thermostat.
How do you install 1997 cadillac thermostat correctly?
Spring goes toward engine block. Install the gasket and tighten to factory specs. Usually 20 lb/ft torque.
