Lift the car with a car jack, remove the tire and set it aside, remove the brake shoe/caliper, and remove the old brake pad. Put in the new brake pad, replace the brake shoe/caliper, put the tire back on the car and lower the car to the ground.
When you remove the caliper, the pads can be pressed out by hand.
No, you need a press to remove and install the bearing.
does a 2002 mazda protege have a front wheel drive
How to Install Front Brake Pads Check Related links below.
Front: 24mm new, 22mm minimum Rear: 10mm new, 8mm minimum
yes
behind the plastic grill on the front.
It does the link between the manifold and the catalyser.
Directly in front of the driving seat.
it is located on the motor in the front
Front: 6x8x2.5" Rear: 6x8x2"
How to Install Front Brake Pads Check Related links below.