When you remove the caliper, the pads can be pressed out by hand.
Lift the car with a car jack, remove the tire and set it aside, remove the brake shoe/caliper, and remove the old brake pad. Put in the new brake pad, replace the brake shoe/caliper, put the tire back on the car and lower the car to the ground.
There is a 14 mm bolt on back of caliper. Remove this & use a 4 mm Allen wrench to back piston into caliper.
1. Remove the brake hose to caliper bolt from the brake caliper. 2. Remove the brake hose from the brake caliper. 3. Remove and discard the 2 copper brake hose gaskets. These gaskets may be stuck to the brake caliper and/or the brake hose end. 4. Cap or plug the opening in the brake caliper and the brake hose to prevent fluid loss and contamination. 5. Remove the 2 brake caliper pin bolts. Remove the park brake cable from the caliper. 6. Remove the brake caliper from the brake caliper bracket.
Lift the car on a vehicle jack, remove the tire, remove the brake shoe/caliper and remove the old brake pads. Put in the new brake pads, replace the brake shoe/caliper, replace the tire and lower the car to the ground.
Remove the high mount brake light retaining screws from your Mazda Protg. Remove the high mount brake light wiring harness. Reverse the process to install your new high-mount brake light.
Torque specs for brake caliper bolts 2005 mazda 6
you need to take off both caliper bolts and remove the caliper from the carriage... most Mazda calipers will not pivot...
To add brake fluid in a 1990 Mazda Protege, you need to locate the brake fluid reservoir and check the levels. The reservoir is located on the master cylinder for the brakes.
Remove caliper (possibly held by 14 or 17 mm bolts) then remove pads from caliper, press piston in and re-fit new pads.
Above the brake pedal,its black plastic.
HOW DO I TIGHTEN EMERGENCY BRAKE CABLE ON A 2002 MAZDA PROTEGE 5?
Next to the master brake cly.