MSD had a module a few years back that would convert a tach signal. Not sure hear da rumor about using a wire off the obdii port, but never seen anyone with a mitsu do it and work. Have seen the MSD tach adapter work superbly.
you can install any kind of tach you want to in your car..if you do not have a stock tach then look in your manual for the rmp sensor wire..should be blue or green coming off the distributor...just splice into it...if you have a stock tach you can just splice into the stock tach wires by taking off the dash
Do you mean an oil pressure gauge? Not tach?
There should be installing instructions with the tach. If not contact the manufacturer.
red wire goes to positive battery white and black wires are for the light white wire being the positve and the green wire goes to the ignition control modtral on passenger side motor on the coil packs it goes to the white wire
Yes, but your 95 headlights will not fit. You will need headlights from a 97,98, or 99.
Yes it can. I own a 95 eclipse and have put a 97 front bumper on it. It is slightly lower to the ground but fits great! it wont fit my eclipse and its a 95
95 eclipse has a low idle
where is the speed sensor located on a 95 eclipse 5 speed
The body style was tweaked in 97. Therefore, the front bumper is not just going to swap out. The headlights are more slanted, so it is not going to fit around them the same.
no
Yes
420 A non turbo 95 to 99