Ratchet wrenches work well.
remove the exhaust pipe from under the motor. then between the motor and transmission you will see a plate with 2 bolts , take them out and then the cover will come off . then turn the motor with flat head screw driver to flywheel until the the nuts are in that opening and unbolt.
The transmission fluid capacity of a 1974 Chevy Nova is 10 quarts. This includes a large amount of fluid which is stored in the transmission and torque converter which is never fully drained.
Torque is the product of (force) x (distance from the center of rotation).So with a distance from the center that's large enough or small enough,any force can produce as much or as little torque as you want.
if large force is applied keeping the minimum moment arm then it produces a very small torque or even no torque.
The knobs on the side of a microscope are the focus knobs. The large one is the course focus, and the smaller one is the fine focus.
The Bessemer steel converter is a large container in which molten iron is converted into steel. The Bessemer steel converter was invented by Henry Bessemer in 1856.
If you are looking for a consumer travel voltage converter, typically any place that sells luggage will sell a converter. Brookstone also sells a good selection of these. If you are looking for a power-conditionings voltage converter for a large piece of equipment, voltageconverters.com has a good selection of converters that are suitable for supporting large equipment.
Some of them do, if that's their function. Solenoids are electric switches. A small amount of current to the coil causes the electric switch to be able to conduct a large amount of current. One application for a solenoid in a transmission is to engage the "lockup" torque converter.
An analog to digital converter can be purchased at any large electronic store such as Best Buy or Radioshack. It can also be purchased at large retailers like Walmart and Target.
None. Diesel Particulate Filters are much different from a car's catalytic converter.
you gotta remove the trans and it is the first thing you see inside the open end of the trans - a large round donut looking steel thing with a short shaft in the middle with a hole in it. You have to loosen three bolts that connect the torque conv to the flywheel it is easiest to loosen these three bolts through the hole left by removing the starter first
it is the course focus