Best Answer

Remove the vent panel located at the base of the windshield. Locate the motor. Replace. Be sure and realign the wipers to specification ... or else, one or both would be offline.

User Avatar

Wiki User

โˆ™ 2009-10-25 18:08:41
This answer is:
User Avatar
Study guides
See all Study Guides
Create a Study Guide

Add your answer:

Earn +20 pts
Q: How do you install wiper motor on 1997 z71?
Write your answer...
Related questions

Will a 1997 Chevy truck transfer case fit a 2001 Chevy silverado z71 with a 5.3L gas motor?

NO. It is all different

What is the wiring diagram on a 1997 Z71?

go 2 google images and type in ,picture of wireing diagram for 1997 chevy z71

What transmission is in a k1500 z71 1997?

It is a 4L60E

Will the 4L60E transmission out of a 1997 Chevy 350 motor z71 4x4 fit into a 1999 GMC 294 motor Sierra 4x4?

Yes. The 4L6oE was intended to be used with the 4.3 - 5.7 liter engines.

Where is a fill tank for the rear wiper fluid on a 2005 Z71?

The fill tank for the rear wiper fluid on a 2005 Z71 is actually the same tank as for the front windshield. If the rear washer is not working and the tank for the front is full, then there might be a problem with a fuse or a hole in the line.

How to change the headlights on 1997 Chevy z 71?

Remove the wiring harness from the back of your 1997 Chevrolet Z71 headlights. Remove the headlight retaining bolts. The headlights will come out. Reverse the process to install the new headlights.

Where is the voltage regulator on GMC Z71 1997?

its inside the alternator

Where are the grease fittings on a 1997 chevrolet z71 4x4?

It has 12

Where is the blower resistor motor located on a 2000 Chevy Z71 pickup?

Should be near or attached to the blower motor

What transmission do you have in your 1997 Z71 5.7 liter?

That would be the 4L60e transmission.

Is a 1997 Z71 transmission the same in 1998 Z71?

the bell housing is DIFFERENT on the 97 trans. You must put a 1993 to 1995 or 1998 are 1999 4L60E transmission back in it. The 1996 and 1997 will not work in the 98.

What is the lug nut torque for a 1997 gmc z71 1500?

Lug nut torque 1997 gmc k1500

Replace a power window motor Chevy Z71?

Pay a mechanic to do it for u

What motor does a 1989 z71 have?

The engine in your truck is a Chevrolet 350 if it a stock engine!

Can you use 10w40 motor oil in a 1997 Chevy z71 instead of 10w30?

Absolutely not.Use exactly what the manufacture recommends and nothing else. You should use 5w30 by what the oil fillcap shows..

Will a 5.3 motor out of a 2003 z71 off road pickup fit on a 1999 Tahoe with a 5.7 motor?


Where is the location of the oil pressure switch on a 1997 GMC Z71 5.7 liter V8?

At the top of the motor, at the back, next to the distributor (a few inches to the driver's side)... just a few inches from the firewall.

What is the Actual Mpg 1997 silverado 4x4 Z71?

13/city 17/highway

How much to replace the alternator for a 1997 Chevy Silverado Z71 - parts and labor?

About $150.00

Can just any 350 motor be used to replace the motor in your 1991 Z71?

No, but hear are the years that will work. 1988 to 1995 350 engines.

Is a 1997 Chevrolet z71 rear end compatible with a 2000 Chevrolet z71?

Maybe but it depends upon what you mean by "rear end". Do you mean the axle and axle housing or the body of the truck? Keep in mind a 2000 Silverado is a different generation than a 1997.

How do you install a standard transmission in a 1994 chevy z71?

Installing a standard transmission in a 1994 Chevy z71 is easy. All you have to do is take the old one out and put the new one in and tightening the bolts back.

Will a 1992 4x4 transmission fit a 1997 z71?

No, The bell housing is different on the 92. You need a 1996 or 1997 4L60E 4x4 transmission.

How do you get to the ashtray bulb on a 97 z71?

To get to the ashtray bulb on a 1997 Z71, the console top needs to be removed. First remove the ashtray from its holder. Then, remove the clips on the sides holding the console top on.

How do you prime a winds hied wiper pump 2001 Sierra Z71 GMC?

Just power the pump. If you have W/W fluid in it, it'll prime itself.