Find the cable that is connected directly to the frame or sub-frame of the car. If it is red, then Positive is ground; If it is black, then Negative is ground. More than likely (but not in all cases) the electrical system is Negative ground.
grounding is always neg on a 12 volt american car. I only know bulldozers that reverse it. hope that helps you out.
Connect positive to positive post (red) on the battery and connect the negative to a place on the engine away from the battery.
I assume you're asking how can you tell which is positive and which is negative? The red cable is positive in the black cable is negative. But if they are not color-coded the positive battery post is slightly larger than the negative battery post. If you try to connect the negative cable to the positive post it would be a tight fit and if you connect the positive cable to the negative post it would be loose.
Connect the positive clip of the battery charger to the positive terminal on the battery. Connect the negative clip of the battery charger to the negative terminal on the battery. Select the charge rate you desire either 2,4, or 6 amp. The newer battery chargers will let you know when it is fully charged.
Current flows form negative to positive. I know this may seem odd considering the the negative is ground, but that is how it flows.
0, Because you don't know how negative or how positive! 0, Because you don't know how negative or how positive!
Following the cables into the engine compartment. The positive cable will run to the alternator or the starter. The negative cable will just connect to a ground source (engine block, frame, etc.)
Cations are always positive, anions are negative.
Negative is the bottom half and positive is the top
because batteries works on the principle of electron charge and an electron can have either a more positive or negative charge but the electron wants to have an equal amount of pos. and neg. charge so when batteries are simply they pull the positive charge to one side and negative to the other side and when they come together with a conductor(wire) it creates a current which does the "work" for you. The voltage of the battery pretty much lets you know how strongly the battery wants to create equality between each side thus more current.
-6 Yes the answer would be -6. But in order to get that answer you must know this: positive divided by a positive = positive positive divided by a negative = a negative negative divided by a positive = a negative negative divided by a negative = positive (also note: it's the same formula for multiplying)
A negative. You really should know that.