Every car has it's own firing cycle. You should label where each spark plug wire goes before you take it off. Number them 1-4 or 1-6 if you have a V6, be sure to take note of where they are positioned on the Distributor cap as well as which plug they go into.
Pull the spark plug wires off the spark plugs. Remove the spark plugs with a spark plug socket. Install the new spark plugs and put the spark plug wires back on. I recomend replacing the spark plug wires as well. If replacing them, just remember that the new wires are hooked up the same ways that the old ones came off.
18436572
The spark plugs are on the front and back of a V6 (back ones are tough to get to) L4 right in front. Turn the engine off and take off the spark wires unscrew the plugs
Replacing spark plugs is pretty simple. Disconnect the battery, remove the cover and cables, remove the old spark plugs, put in the new spark plugs, put the cover and wires back on the spark plugs, and reconnect the battery.
probably on top of the middle of the engine back by the firewall follow the spark plug wires from the spark plugs back
there are 3 in the front and 3 in the back if its a 6cyl.
they could be bad spark plugs as in not a very good brand. or maybe you didn't put the wires back on the right spark plug.
You have to take coil packs off and then they are easier to get to. You will see the wires going to the plugs.
If you look at all the rubber wires, ( 8 of them ) on the back of the engine behind the air filter. Each one of those wires hook to a spark plug in the heads that is on both sides of the engine. 4 spark plugs per side.
It is in the very back of the engine. Just follow the spark plug wires from the spark plugs and they will go to the top of the Distributor. That will be the distributor cap that the wires are in.
Ok, I have figured it out. The coil is putting off what looks to be a good spark, but It is not strong enough to go through the gap between the cap and rotor to get back to the wires. I replaced it and it works!!
ummm follow the spark plug wires from the three little black boxes on the back/top of the intake to the block u will find three plugs in the front and three in the back