answersLogoWhite

0


Best Answer

Which engine? If this is a check engine light or emissions test failure be certain ex. gas & intake passages are clear. Bob

User Avatar

Wiki User

โˆ™ 2015-07-15 21:18:26
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: How do you locate and replace the EGR Valve on a 1996 Ford Contour?
Write your answer...
Submit
Related questions

Where is PCV valve located on a 1996 Ford Contour?

Where is the PCV valve located on a 4 cyl ford contour and will this if replaced will let my service engine light go off?


Where is PCV valve locate on 1996 s-10 pickup?

On top of the valve cover on the passenger side


Where is a canister purge valve located on 1996 corolla?

locate it next to engine


Why would a 1996 Ford Contour idle rough once it gets hot?

possible vacume leak in the egr valve or bad valve itself.


How do you replace an O2 sensor on 1996 ford contour?

It unscrews just like a spark plug.


Your heater will not blow on your 1996 Ford Contour?

heater will not blow on a 1996 ford contour


How do you remove the dash panel on a 1996 ford contour?

how to remove the vent from dashboard of 1996 ford contour


Where can you locate the PVC valve on a 1996 ford bronco with the 58 efi?

Ford hid the PCV underneath the intake manifold, in the rear of the passenger side valve cover.


Where is the PCV valve on a 1996 Buick Park Avenue and how do you replace it?

It is in the intake behind the throtle body. Simply pull it out and replace it.


How do you replace a fuel pump on a 1996 Ford Contour 2.0L?

Can you open back seat and look fuel pump then replace fuel pump easy job. Wendell


How do you replace 1996 Chevy lumina egr valve?

remove the 2 bolts andharness


Where is the PCV valve in a 1996 jeep wrangler and how do you replace it?

PCV valve is on top of one of your valve covers and it should just pull out there should be a big rubber line on it


How do you replace the water pump on a 1996 Ford Contour 2.0L 4 cylinder?

You have to take the timing belt off it is located behind it


How do you replace valve seals in a 1996 Saturn SL1?

You replace the valve seals on a 1996 Saturn SL1 by removing all of the hardware to get to the valves, unseating them, cleaning them, and sliding the new valve gaskets on. In order to do this you should consider getting a good Chiltons or other repair manual for your make, model, year, and engine.


How do you fix high idle problem on 1996 VS commodore?

To fix high idle problem on a 1996 VS Commodore, first locate the idle air control valve. Unscrew and unplug electrical connector running to the valve. Turn the valve over and clean the sensor for debris.


How do you replace the egr valve on a 1996 Chevy sliverado?

In front of the radiator between the grill and the radiator


How do you replace a fuel pump on a 1996 Ford Contour 4-cylinder?

Can you open back seat and look fuel pump then replace fuel pump easy job. I did my car. Wendell


How do you replace an O2 sensor on a 1996 ford contour?

You will see it if you look directly at the front of the motor. It will have a thick white wire and is screwed in the motor.


How do you change the coolant in a 1996 Ford Contour?

How do you add freon to a 96 Ford Contour


How to locate and replace crankshaft sensor on 1996 Oldsmobile Achieva 2.4 liter engine?

did u ever figure it out?


How do you remove and replace the AC expansion valve on a 1996 S10 6-cylinder Chevy Blazer?

Remove the bottom hose from the evaporater at the firewall, pull out the expansion valve, i highly recommend flushing out the system to remove excess sludge. Replace the valve and the hose.


Is a 1996 ford contour transmission the same as a 1996 ford ranger?

No. The Contour is a front-wheel drive car, and the Ranger is rear wheel drive.


When you first start your 1996 Toyota Camry 4-cylinder will not idle?

You need to replace the EGR valve. Make sure to replace the plugs too after that.


Can you replace a water pump on a 1996 ford contour 2.0 without messing with the timing?

The water pump is driven by the timing belt, so.....afraid not.


How do you replace water pump on 1996 2.0L ford contour?

You take it to the shop. You have to take off the timing belt to do the water pump