Want this question answered?
how to locate engine coolant temperature sensor on a 1999 Cadillac De Ville Concurs
under hood in engine compartment check under dash also
where is the coolant temperature sensor locate
Locate the starter at the rear of the engine on the passenger's side. Unplug the wiring. Remove the bolts that hold the starter. Remove the starter.
coolant temperature sensor are located where the coolant runs in the block near the thermostat housing normally the connector are on top of the sensor and the sensor itself screws in with a deep socket. The temperature sensor is usaully located where the coolant runs OUT of the engine close to thermostat housing.
The coolant for a BMW x5 is placed into the coolant overflow tank on the left side of the engine compartment. It should be filled to the full mark when the engine is at operating temperature.
The Fiat Punto has a radiator which receives coolant in order to keep the temperature down. The diagram of this radiator can be found in the owner's manual.
It is just below and behind on the area where the upper radiator hose attaches to the engine.
Rewiring a temperature is absolutely necessary when the wire has frayed since the temperature gauge in the car will not work with a burnt wire. Locate the frayed wires and cut them off. Measure the amount of new wiring needed and solder them on.
The 1998 Mitsubishi Montero Sport has the most common hook-end wiper arms. See Sources and Related Links below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.
pop the hood, locate the coolant reservoir tank (has a cap with psi and temperature warnings) look on the side of the tank, and there will be a max and a min line. should be filled to min when the motor is cold. hope this helps.
To drain the coolant on a Mazda 626, locate the drain plug on the bottom of the radiator. Remove the plug and drain the coolant into a pan.