loosen the bolt in the center of the drive belt pulley, then loosen the bolt on the side of the pulley. as you loosen the side bolt the tension lets up
Loosen bolt in tension pulley, then loosen tension bolt. Replace belt. Tighten tension bolt. Last, tighten bolt through pulley.
Loosen lock nut, turn tension bolt.
socket and force bar on bolt brace against frame and use starter to loosen
Loosen the 15mm nut that holds the pulley to the bracket then back off on the 13mm adjuster bolt.
which way do you turn the harmonic balancer bolt on a 95 geo tracker to loosen it
If you looking behind or on the side of the power steering pump, you'll see a bolt. When you loosen the bolt, the pump will slide down and loosen the belt.
you loosen the bottom bolt first. then you loosen the top bolt and it will move. the you can just take the belt off of it. one wire will just unplug and the other you have to take the bolt off.
To loosen the bolt, use a socket wrench. You might use the frame for leverage, and you may need some starter or grease on the bolt to give you some give.
On a Mazda MX-3 (1994) you need to tighten the adjustment bolt that is close to the fire wall. Tightening the bolt loosen the belt - loosening the bolt tightens the belt
That refers to the size wrench necessary to tighten or loosen the bolt.
On my 97 3.5L you have to loosen the bolt (15mm)on the front of the idler (loosen, don't remove) then go underneath and the is a 13mm bolt that adjusts the position of the idler for tension. Loosen this and the idler should loosen up.