Chevy Camaro

How do you make the speed sensor work as you changed transmissions from a 1999 to a 1996 Chevrolet Camaro 5 speed?

789

Top Answer
User Avatar
Wiki User
2008-09-07 23:09:13
2008-09-07 23:09:13

You need to check with the parts house and see if they are the same sensor. Do they both have the same number of teeth.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The throttle position sensor is located on the throttle plate.

User Avatar

usually a bad wheel sensor, get it checked out.

User Avatar

It is on the intake manifold near the thermostat housing.

User Avatar

the knock sensor on a 91 camaro 305 in on the passenger side of the block, bellow the exhaust manifold. its a few inches in front of the bell housing., and has a single wire running to it. looks a bit like a temp sensor, or oil pressure sensor.

User Avatar

You did not specify as to the engine size. Generally they are located in the air tube from the air filter to the throttle plate.

User Avatar

It will require a special slotted socket that can only be used for the one purpose. The cost does not justify the means.

User Avatar

how do you change a crankshaft position sensor on a 1999 chevy camaro z28?

User Avatar

The position of the camshaft sensor on your 1997 Camaro is dependent upon the type of engine in the Camaro. In most cases the camshaft position sensor is on the back of the left-hand cylinder head.

User Avatar

No, it uses speed density the 2.8 v6 camaro uses a MAF sensor.

User Avatar

That year did not have a crank sensor.

User Avatar

There is no crank sensor on a 1986 camaro z28.. that sensor is in the camaros past 1988 i believe.. but the 1986 carb or fuel injection (tpi) does not have one

User Avatar

That year did not have a cam sensor.

User Avatar

That year did not have a MASS AIR FLOW SENSOR / ( MAF )

User Avatar

A sensor has failed, and is reporting the wrong value to the transmission controller. Old transmissions: Probably the vacuum modulator or throttle position sensor. Also check the fluid level. New Transmissions: Output speed sensor, turbine speed sensor, throttle-position sensor, fluid pressure sensor, and sensors on the engine.

User Avatar

The MAP sensor on an '86 Camaro with a 2.8 liter engine is located by the distributor at the rear of the intake plenum. There will be a black plastic casing that needs removed to gain access to the sensor.

User Avatar

On a 1999 Camaro, the map sensor is located on the back of the intake manifold. The intake manifold is the series of tubing that distributes the air coming into the engine.

User Avatar

Why would you want to disconnect it other than to keep your mileage down. That also works in conjunction with the ABS. If it is disconnected then it will show up in history codes.

User Avatar

where is the speed sensor located on the 2004 Chevrolet suburban 4 wheel drive z71

User Avatar

The oil pressure sensor, on a 2008 Chevrolet Impala, is located on the front of the engine. The sensor will be just above the oil pan.

User Avatar

That year did not USE a Crank sensor.

User Avatar

The 2001 Chevrolet Suburban is equipped with one knock sensor. The knock sensor will be attached to the back of the engine.

User Avatar

mass air flow sensor or manifold pressure sensor. your car will have either or.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.