Run a wire from the POSITIVE terminal on the battery and touch the red wire (positive) to the window motor and run another wire from the NEGATIVE terminal on the battery and touch the green wire (negative) to the window motor. The window should go down. Reverse the wires to make the window go up.
It cannot be raised manually. You will have to repair it in order to raise the window.
I had to to take the door panel off remove the window motor raise the window then put the motor back on
take the door panel off and disconect the wire assembly or window regulator that goes to the power window moter and manually pull the window up.
You have to disconnect the glass from the regulator or clip the regulator cables.See this post for instructionshttp://www.ricksfreeautorepairadvice.com/repair-topics/window-power-repair/replace-a-power-window-regulator
How do you manually raise the power windows on chrysler sebring?
Yes, remove the door panel, remove the window motor. You should be able to lift the window up.
You can manually roll up a power window by pulling on it. You can also remove the door panel and pull the window up.
No, not without removing the door panel to gain access to the motor unit.
You cannot manually close a power window. You must repair the problem causing it not to work. Check the fuse, power window switch, and if they are good, you may need a new motor.
the only way i know is to disconnect or remove the motor and manually move the window up until the motor is replaced. sometimes also it could be just the switch.
No.
try removing switch, and jumping the wires, this should raise window with out pulling door apart