0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is pitch of a filet weld?
Pitch is center to center spacing of an intermittent weld.
How to do CONCAVE filet weld?
Eat a banana.
Leg or filet weld?
Leg of the weld. Fillet is the part you cut off e.g. a corner...
What part of a filet weld that can be convex or concave?
The 'face' of the weld may be slightly convex, flat, or slightly concave.
How do you measure filet weld?
In a fillet weld, the leg and size are the same for the convex weld.
What term refers to the center-to-center spacing of intermittent filet weld?
Pitch
What is the filet weld size required for weldolets to main pipe joint?
wildly welding main pipe the are fillet weld or butweld
What is the Five parts of a filet weld?
leg,toe,face,throat,root joint
What is the difference between Full-penetration butt welds and filet butt weld?
tell me full penetration joint process
What is definition of the under run in filet weld?
A fillet weld in any single continuous weldmay underrun the nominal fillet weld size specified by2 mm [1/16 in] without correction, provided that theundersize portion of the weld does not exceed 10% of thelength of the weld. On the web-to-flange welds on girders,underrun shall be prohibited at the ends for a lengthequal to twice the width of the flange.
How do you measure penetration in welding?
To measure penetration of a weld, one must cut and etch the weld, preferably on a test coupon. Etching is just using an acid that will discolor the weld metal so that there is a visible difference between the weld metal and the base metal. Once the acid has taken affect, one can measure the weld using calipers or a similar measuring device.
What parts of a filet weld are measured?
The distances from the root to the edges of the legs (toes) and the height of the crown are basic measurements. If the face is concave it might be considered.
