Honda Civic
Mercury Sable
Ford Explorer Limited

How do you open the hood on a 1990 Honda civic when the cable is broken?

151617

Top Answer
User Avatar
Wiki User
Answered
2006-10-20 14:18:49
2006-10-20 14:18:49

well its a half fast way but it werx if ur cable broke on da inside of ur car, all u need to do is grab da inner cable with vicegrips , but if u cant ,cut da outter cable {like stipping a wire} it will expose more inner clamp onto it and give it a tug

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


How do you adjust the kickdown cable on a Honda Civic 2000 ex

Let me know if you have found out the answer to this question i need to disarm my 1990 Honda civic also

What size gas tank does the 1990 Honda Civic Hatchback have?" i have a 1990 civic and i have never been able to put in more than 10 gal.

Try looking at the workshop manual http://manualfile.com/Automotive/Honda/honda-civic-1988-1990-workshop-manual.html

what is code 14 in Honda civic 1990

NO, they have two completely different motors.

The starter of a 1990 Honda Civic is located on top of the transmission housing. There are two bolts mounting the starter to the transmission.

they might need a little modification, but probably not much.

Yes, it will fit, as they are both D-series motors. However the 95 Civic has a hydraulic clutch, and the 90 crx is just a cable clutch. Also, the 90 CRX motor is OBD0 and the 95 Civic is OBD1.

You can find a 1990 Honda Civic SI wiring diagram in the car's owner's manual. You can also check with local auto stores.

My 1990 Honda civic LX took 2 pounds of refrigerant when i got it refilled from completely empty.

No. The Prelude has a B20A5 motor. The civic will have a D-series tranny. They will not interchange (B and D series parts do not interchange).

The coolant capacity of a 1990 Honda Civic is 7 quarts or just under 2 gallons. It uses a mixture of anti-freeze and water at a 50/50 ratio.

First follow the cable out from the driverside firewall all the way across the motor and down the passenger front. The cable has a plastic nut that turns by hand.Its a little bigger then a bottle cap.

it is in the exhaust manifold,or exhaust pipe...

Yes it will. Make sure you replace your motor mounts as they are most likely torn.

go through the grill and use a heavy duty screwdriver to pry back the latch

There is no fluid in the system or master cylinder/slave cylinder failure (hydraulic). Cable streched or broken (if not hydraulic).

the D16Y7 or the D16Y8 the D16Y7 or the D16Y8


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.