Read here...I just did it. Mine was actually easier than indicated here as the cover was simply velcroed on....
http://autorepair.about.com/library/faqs/bl404h.htm
Remove the tail light housing and replace the bulbs.
On a 1989 Acura Integra hatch back the brake lights are reached through the hatch itself. The brake lights housing are on the rear of the vehicle. Unplug the bulbs and replace them.
To replace the brake light on a 2000 Pontiac Montana open the trunk to reveal the housing units. Find the lights and pull the bulbs out. Replace the units.
The brake lights are located in the trunk of a 1997 Acura Integra. To replace them open the trunk and find the plastic housing. Remove and replace the bulbs.
Someone can replace brake lights by unscrew the tail light housing, pull it out. Then unscrew the pulp holder and take out the old pulp. Then put in the new pulp, then screw back all other unscrewed parts.
Could be the brake light switch or fuse.
S13 - 10amp
Remove the wing nuts from inside the trunk. Just pull the housing out after.
are you sure it is the brake lights and not the tail lights. if it is the brake lights you most likely have a short some where. go to a auto eletrican It is the brake lights which turn on. Short in the switch or the wiring?
Just turn the housing the bulb is in and pull it out. Remove and replace the bulb the same way. For the rear lights, you have to push on a tab to release the housing the bulbs are in.
The lamp in the top brake light of a Toyota Highlander can be replaced by the locating the light housing from the trunk. Find the light cover and remove it to access the lights. Replace the bulbs.
replace front brake pads