If I remember correctly, those models may be old-style 'push-button' type radios? If so, do the following:
1) Select the 'station' or frequency you want to store as a pre-set by turning the right (tuning) knob.
2) Pull the 'push-button' mechanism out towards you all the way (one click, usually) -- it may take a little more effort than you think or you way need to lift up slightly on the push-button to get it to move, especially if it's been a couple of decades.
3) Push the 'push-button' back in all the way -- the linear mechanism on the dial should not move at this point.
4) Test your new pre-set by moving the dial to the left or right using the right-hand (tuning) knob then pushing the same 'push-button' in. The linear mechanism -- if working properly -- should now move the dial to your new location and change the frequency to your chosen 'station'.
On new (digital) radios in cars & trucks, of course,with the radio on you tune in the band and frequency (and in some cases a 'bank' of presets [such as 'FM1', 'FM2', 'XM1' / 'SAT1', or 'AM1']) that you want to store then push 'set' then push the preset number you've chosen OR push-and-hold the chosen pre-set button (generally the radio will beep and / or flash the display and / or audibly re-tune the station once the setting has been stored) with the 'push-and-hold' method it may take up to three seconds in some cases for the setting to 'take'.
If you're having issues, hold the button in a bit longer until you get some sort of reaction from your radio and / or watch the radio's display to see if there is a message or prompt, as in many cases the radio may ask you if you REALLY want to change an existing preset, or the radio may need more information such as the 'bank' [again, meaning something like 'FM1', 'FM2', 'XM1' / 'SAT1', or 'AM1']in which you want to store the preset. Hope that helps!
AnswerShould just be able to select desired station and hold button for 3-5 seconds until blinks AnswerShould just be able to select desired station and hold button for 3-5 seconds until blinks1995 Buick LeSabre how do i reset my radio
You will have to reprogram all the preset radio stations ( if that is what you are referring to ? )
located in back window with rear defog
If you disconnect a battery cable the preset radio stations and the clock has to be reset
fuse #44 behind left side of dash
yesgo to walmart and buy a plug kit
installdr.com
When you disconnect a battery cable all the preset radio stations ( and the clock ) have to be reset
remove the screws and give it a slight tug
Most you tune to stations you like and push/hold preset buttons 1 at a time.
For my radio, you simply select the station you want and then hold the preset button down for about 5 seconds. The station is now set to that button. Note: Each of my 6 preset buttons will select two stations each, so you first must select the first or second preset, by tapping it once or twice, before performing the 5 second hold down.
If you disconnect a battery cable , all the preset radio stations will have to be reset , along with the clock time etc.