0
How do you program a 2005 Malibu ignition switch with the anti theft system?
Wiki User
∙ 9y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you disable theft system in Chevy 2004 Malibu classic?
Turn ignition switch on ,(don't start car) for about 10 min that will disable theft system.
Does a 2002 Chevrolet Malibu have an abs brake system?
I feel it does being it is that new. Turn the ignition switch to the "ON" position. If a yellow light comes on saying abs, then it does.
How do you turn the anti-theft system light off on a 2002 Chevy Malibu?
For a 2001 Malibu, you leave your key in the ignition switch turned to the accessory position for 10 minutes. Turn the car off after that and then start it up like normal.
What could cause a 1971 Chevelle Malibu to start but doesn't shut off when you replaced the ignition switch but nothing changed Besides the whole ignition system what else could it be?
Something is keeping power to the ignition coil. You need a wiring schematic and trace the wiring.
Is there a reset switch for the ignition system for a 95 blazer?
No there is not.
2000 Toyota Camry have a ignition switch fuse?
A 2000 Toyota Camry has an ignition switch fuse location in the main fuse panel. It helps protect the switch and the rest of the ignition system from surges.
Is there a fuel shutoff switch on a 2001 Chevy Malibu?
No, the system is computer controlled with relays.
Will a bad ignition switch shut down the electrical system on a 1994 Chevy truck?
A bad ignition switch can shut down a vehicle's electrical system. Ignition switches have been the cause of a major recall by General Motors.
How do you program a key fob to a 2003 Chevy Malibu?
Try this first. It worked on mine. Close all the vehicle doors. Insert the ignition key into the ignition lock cylinder. Press and hold the DOOR unlock switch. While holding the DOOR lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF. Release the DOOR unlock switch. The doors will lock and unlock to confirm the program mode. Press and hold the LOCK button and the UNLOCK button simultaneously on one keyless remote. After a delay of approximately 15 seconds , the doors will lock and unlock to confirm the programming of that transmitter. Repeat the previous step to program up to four transmitters. Turn the ignition switch to the RUN (one more click forward) position in order to exit the keyless entry transmitter mode. Operate the transmitter functions in order to verify correct system operation
What would cause a 40amp ignition batt fuse to blow on a 97 Malibu?
There is a sort somewhere in the starting system
How do you reset the alarm system on 2002 Chevrolet Cavalier?
Turn the ignition switch to the auxiliary position. Do not start the engine. Leave the ignition switch in the auxiliary position for 30 seconds. This will reset your alarm system.
How do you program a remote for a 2006 Dodge Caravan?
The instructions on in the book that came with the van. Customer Key Programming You can program new sentry keys to the system if you have two valid sentry keys by performing the following procedure: 1. Cut the additional Sentry Key Transponder blank(s) to match the ignition switch lock cylinder key code. 2. Insert the first valid key into the ignition switch and turn the ignition switch ON for at least 3 seconds but no longer than 15 seconds. Turn the ignition switch OFF and remove the first key. 3. Insert the second valid key and turn the ignition switch ON within 15 seconds. After ten seconds a chime will sound and the Theft Alarm Light will begin to flash. Turn the ignition switch OFF and remove the second key.
